answersLogoWhite

0

  • Cadillac Catera
  • Ford Expedition Eddie Bauer
  • Ford Expedition XLT
  • Ford Explorer XLT

How do you remove the inside drivers side door panel on a 1998 Cadillac Catera you can't get it past the lock?

User Avatar

Wiki User

βˆ™ 2006-09-19 21:44:33

Best Answer
Copy

You have to remove the lock plunger. The red plastic inset in the plunger actually locks the plunger onto the "threaded" shaft. Pry out this center piece and the lock plunger will come off the top...and the rest of the door panel can be removed.

2006-09-19 21:44:33
This answer is:
πŸ€“
🀯
πŸ€”
User Avatar

Add your answer:

Earn +5 pts
Q: How do you remove the inside drivers side door panel on a 1998 Cadillac Catera you can't get it past the lock?
Write your answer...
Submit

Related Questions

How do you inatall heater core in Cadillac catera step by step?

how do you remove heater core in cadillac catera?


How do you remove the fuel pump from a 2003 Cadillac catera?

There is NO SUCH THING AS A CADILLAC CATERA FROM 2003...They stoped making them in 2001


How do you remove valve cover gasket on 1997 Cadillac catera?

i am going to change the valve cover gasket on my 97 cadillac catera, what do i need to remove and do? Is it hard?


How do you change fuel pump in a 1997 Cadillac Catera?

The fuel pump is inside the gas tank. You must remove the tank to change the pump.


How do you remove the engine cover on a 2005 Cadillac Catera?

well not for how but cadillac cateras were only made from 1997 to 2001


Where is the radio fuse located in a 1998 Cadillac Catera?

The battery fuse for the radio in the Catera is located in the fuse box underneath the steering wheel. There is a cover you have to remove and a guide to the fuses is imprinted on the inside of the cover, which will tell you which one is the correct fuse.


Where is the power window relay in a 97 Cadillac STS.?

The 1997 Cadillac power window relay switch can be found inside of the drivers side door. You will need to remove the inside door panel in order to access the power window relay switch.


How do I remove a Cadillac Catera center armrest?

If you are talking about the arm rest lid, you have to remove the screws at the hinge. If you are talking about the base, it is part of the console and requires more work.


Where is the brake light switch on a 2000 Cadillac Catera?

at the top behind brake pedal, don't remove the lower switch it for the cruise control


How do you reset the computer on a 1997 Cadillac Catera?

The way that it works on most vehicles remove the positive side battery cable for 10 to 20 min


How do you remove drivers side mirror?

remove drivers inside door panel and there are 2 or 3 bolts that hold mirror on from the inside after you diconnect the wire harness if it is a power mirror


How do you remove gas tank on 1997 Cadillac deville?

take out inside the car


How do you remove rear deck speaker from 06 Cadillac dts?

You have to do it from the inside of the trunk.


Where are the spark plugs located on a 2000 Cadillac Catera?

Under the throttle body. It is not difficult to remove. Look it over good. there are a couple hoses and a clip then remove the bolts. It should lift of quite easily.


Why does your 1998 Cadillac Catera only have heat on the passenger side?

Sounds like the actuator on the drivers side is not operating properley. To check it out, remove the panel under the steering wheel, reach up to the actuator arm and try to move it to its bottom position, if heat comes out you solved the problem.


Are the rear brakes for a Cadillac Catera drum or disc?

Disc. Remove the wheel. Look on the backside of the caliper and you will see the bolts that hold it. Pretty much the same as any other.


Location of the computer on a Cadillac Catera 2000?

under the hood in the fuse/relay box. grasp it and pull it straight up and out, assuming you need to remove it. for good diagnostics, go to cadillacforums.com and join the catera/cimarron subgroup. they have every answer known to man for cateras on that site.


How do you remove drivers headrest Volvo s40?

How do you remove the inside driver's door panel on a 2000 Volvo S40?


How do you replace the drivers side mirror on a Chevy Cavalier?

Remove the inside door panel of your Chevy Cavalier. Remove the drivers side mirror wiring harness, if the mirror is electric. Remove the drivers side mirror retaining bolts. Reverse the process to install the new drivers side mirror.


Where is the fuel pump located 2001 Cadillac devilled?

Your 2001 Cadillac DeVille's fuel pump is located inside of the fuel tank. to remove it you must remove the fuel tank from the bottom of the car. with the tank out, remove the locking ring the part that comes out is the fuel pump and level sensor. Cadillac Man


How do you remove the radio on a 1999 Cadillac Catera?

look at these sites: http://www.tele-tukku.fi/pdf/mtu/70369.pdf http://www.metraonline.com/downloads/pdf/TurboKits/INST99-2004.pdf


Where is the fuel pump on a 2000 Cadillac Escalade?

It is inside of the fuel tank. You will have to remove the fuel tank to service it.


On a 1997 Cadillac Catera if the fusebox is located under the dash on the drivers side do I need to remove the cosmetic panel to find it?

Yes, there are two 1/2 turn screws that must be turn to release. The panel will still be held in place by two round metal pegs- so lift it up slightly and it should release.


How do you reamove the headlamp on a 2001 Cadillac Catera?

Your best bet is to remove center grill 1st. Then, access to the headlamp is much easier. You might also have to remove trim piece unde headlamp but, it simply pops in. Also, on those headlights, there is a center reflector piece inside the lamp itself. This is what the bulb goes in. Unfortunately, it is common in these cars that this piece becomes detached from the headlamp unit and floats around inside there...causing your beam to be up or down.


How do you replace outside drivers door handle on 1998 cadillac deville concours?

remove inside door panel,let window all the way up and remove related linkage and unbolt handle,installation is the reverse of removal, you'll need a 10mm socket or maybe an 11mm,remove two bolts holding handle in place.