Chevy Impala
Isuzu Trooper
Ford Expedition XLT
Ford F-150

How do you remove the interior door panel on a 1998 trooper?

585960

Top Answer
User Avatar
Wiki User
2006-10-05 03:12:08
2006-10-05 03:12:08

I have a 1995 Trooper. There are 3 screws that must first be removed: 1. Door handle 2. Rubber Handle 3. Rubber Handle. Take those 3 screws out then, with your hands pull the interior away from the door. There are some plastic thingies that will pop as you do this. Use care not to damage the wires on the entrance light like I did. You'll have to twist the door handle to fit through the square opening. Lift the panel away from the door and remove the power window switch. Unplug the power window switch and panel should be ready to set aside. Hope this helps!

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

I have a 1999 Trooper, perhaps your fuse panel is in the same location as mine. Look to the left of your brake pedal along the interior wall where your left foot rest. If not look to the left of the steering column where the dash ends, almost underneath the dash, you'll probably have to lay on your back to see it. Hope this is helpful.

User Avatar

One screw near the handle three under the pull handle then pry with screw driver or interior panel remover.

User Avatar

Remove the visible screws on the panel. Remove the screw and interior door handle cup. Tap the panel upward. DO NOT PRY OUT FROM DOOR! you will break the tabs that slide into the steel part of the door. Onece it is lifted staight up off the door remove the wiring connections for mirror and windows.

User Avatar

next to the ecu, drivers side remove interior sill plastic trim and kick panel

User Avatar

does any one no the answer because i have the same question

User Avatar

just use a minus scre driver and slide thru the interior cover, it will snap off the body.

User Avatar

Check out the post for changing the front speakers, same thing or The answer to the question can be found in the following site: http://www.mustangevolution.com/articles/20073/

User Avatar

How do you remove the instrument panel in a 1998 Ford Expedition 5.4 Engine

User Avatar

The 1998 Ford Ranger door panel has eight retaining clips. Pry outward on each retaining clip. Remove the two door handle screws.

User Avatar

It is not too hard. You will have to remove the door panel, then you will see how the interior handle is riveted to the metal door frame work. You will need to drill these rivets out and install the new handle with either rivets or screws.

User Avatar

The kick panel is the interior plastic trim panel ahead of the front doors on the passenger and driver side next to the persons feet

User Avatar

Using a blunt putty-knife or a broad blade screwdriver pry out the cargo hook and the lower access panel. Using the putty-knife (or a trim removal tool) working slowly and carefully, prying around the outer edges of the panel to work the panel clips loose until the panel is free. After all the clips are loose carefully lift away the panel - unplug any wire harness connectors and remove the panel.

User Avatar

Remove center stack bezel (radio, heater control), remove screws from instrument trim panel at ctr stack and remove instrument trim panel, remove dash top panel, replace speakers.

User Avatar

remove black plastic panel on inside behind mirror. remove switch panel by pushing forward then lifting up. disconnect wiring. remove panel covering door handle[one screw]. remove screw behind this panel. remove screw at top of arm rest from underneath rest. remove screw from underneath back corner of armrest.now lift straight up on door panel.

User Avatar

The drivers side kick panel is in the drivers footwell , just ahead of the drivers door It is an interior trim panel by the drivers left foot

User Avatar

remove the door panel screws and pull up on the door panel to correctly remove it. then remove the 3 bolts on the upper corner and unplug and replace

User Avatar

wear gloves, bearings all come out. then you have to remove the sensor off the back of it. along with 6 17mm bolts. How do you change the rotors in the front on a 1998 Isuzu Trooper

User Avatar

The 1998 Chevrolet Blazer door panel is held in place by eight retaining clips. Pry outward on each retaining clip to remove the door panel.

User Avatar

To remove the headliner on the 1998 Ford Escort, first remove both of the visors by removing their screws. Then, remove the trim from around the edges of the interior roof. Then, pull the headliner down from the ceiling.

User Avatar

Door Panels Removal & Installation 1. Remove the sail panel. 2. Remove the door panel by carefully lifting the panel upward to release the retaining clips. 3. Remove the electrical plugs that control the windows, exc. 4. The installation is the reverse of the removal.

User Avatar

by the drivers side kick panel under coin holder labeled "dome"

User Avatar

in the fuse panel either under the dash on the drivers side (remove interior plastic pieces) or under the hood hear the battery

User Avatar

To remove the instrument panel from the 1998 Mitsubishi Eclipse, carefully pull back the pod. Take care not to lose any of the clips.

User Avatar

How do you remove the driver side door panel of a 1998 VW Beetle to replace the door handle cable?


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.