Starters and Ignition Systems
Ford Explorer
Pontiac Grand Am
Grand Prix SE

How do you remove the key when stuck in the ignition of a 1996 grand am?

272829

Top Answer
User Avatar
Wiki User
2007-11-17 03:02:38
2007-11-17 03:02:38

on the bottom of the steering column there is a small rectangular plastic plug that pops out (small flat screw driver works good) pop this cover off and there is a button inside. hold that button in and it unlocks the ignition allowing you to get your key out. (the button pushes in toward the cab of the car) hope this helps

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

put it into park, i made the same mistake and couldn't get it out for ages!

User Avatar

1996 rodeo- how to remove key from lock ignition?

User Avatar

Chevy Tahoe Ignition Key Starter Switch

User Avatar

on either side of the key insert is are peices of metal that can be depressed with a screw driver or pencil. Depress and turn. Hope this helps.

User Avatar

Where all the wires plug into. That is the ignition coil. The ignition coil is inside the distributor behind the cap. Remove the distributor cap screws, remove the cap and you will see the coil.

User Avatar

The coil is on the passenger side of the engine

User Avatar

i have a 1996 varago..to remove the ignition switch you must remove the head light Lind's and all that is inside will be able to see the screws that holds the switch in

User Avatar

The ignition coil is inside the distributor behind the cap. Remove the distributor cap screws, remove the cap and you will see the coil

User Avatar

Just trying to help my sister Terri with her Corolla.Moe

User Avatar

It is part of the distributor and is not serviceable separately.

User Avatar

This is a sping lock DIY video and explains very well in this video how to remove your ignition, hope it helps http://www.youtube.com/watch?v=tETEtb5Yr_o

User Avatar

Begin by removing the retaining ring at the top of your 1996 Mercury Tracer ignition switch. The ignition lock cylinder will slide out. Remove the wiring harness from the end of the cylinder. Reverse the process to install your new ignition lock cylinder.

User Avatar

you have to remove the timing chain in order to remove the cam covers

User Avatar

Insert the key into the ignition. Push the release/switch button at the bottom of the cylinder, and pull the cylinder out.?รฆ

User Avatar

Remove the 3 coils which are help on by 2 5.5 mm bolts each. The module is now free. Remove electrical connector from ignition module. - Tech JK -----------------------------------

User Avatar

Watch this video: http://www.youtube.com/watch?v=reonxApWkVU

User Avatar

i need to remove the rear driveshafts to take out the diff from my 1996 jeep grand Cherokee auto 4.0 petrol can you help me please

User Avatar

Disconnect batter ground cable. Remove the upper and lower steering column shrouds. Remove lock screw and disconnect ignition switch electrical connector. Rotate the ignition switch to the RUN position. Remove the two screws retaining ignition switch. Disengage ignition switch from the actuator. When installing new key set, ensure new key set is in the RUN position prior to installion.

User Avatar

The starter relay is out. Or the ignition module. Or the ignition switch is out. And its the odds in that order. Greatest to least.

User Avatar

In the front bumper. Drivers side. You have to remove the underpan plastics to get to it.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.