the acutually dash removal of the Comfort-Control Toggle Switch in order to remove facing for radio replacment of 1990 nissan maxima?
Get a manual on your car from AUTOREPAIR2000.COM
remove front door panel 1995 Nissan maxima
How do I remove An 87 Nissan maxima gas tank
You need to remove the rear seat. There are a series of bolts and clips that need to be undone. I recommend reading/purchasing a Haynes manual - they have complete steps on how to perform this.
ac and heating fan control switch is needing replaced. I need to know how to remove and re install new one on a 2005 chevy silverado Z71.
what year maxima? please email email@example.com In i can tell you how to do it..
You can take your battery out and put it back in. Or find the appropriate fuse (in your owner's manual), remove it, and put it back in.
remove the whole front end
To remove the harmonic balancer from a Nissan Maxima, first you need to removed the center bolt. After that, you can use a puller to remove the harmonic balancer. Before you do this, make sure you disconnect the battery and remove the drive belts.
twist then pull
You will need to get a repair manual for this because you will be pulling the dash and the complete a/c-heating box out, very complicated......................
Heating will do it.
i BELIEVE YOU NEED SPECAIL TOOL MAYBEyou do not need a special toolDisconnect battery ground cable.Remove the air cleaner outlet tube.Remove the manual control lever nut securing the manual control shift outer lever to the manual control lever.Remove the manual control shift outer lever from the manual control lever.Transmission Range Switch Electrical Connectors Disconnect the three solenoid electrical connectors located on top of the transaxle.Disconnect the solenoid electrical connectors located on the front side of the transaxle case.Remove the two retaining bolts securing the Transmission Range (TR) switch.Transmission Range Switch Remove the bolts securing the solenoid electrical connector brackets to the top of the transaxle case.Remove the TR switch from the manual control lever.INSTALLATIONPosition the TR switch on the manual control lever.Install the bolts securing the solenoid electrical connector brackets to the transaxle case.Install the bolts securing the TR switch, but do not tighten them.Connect the three solenoid electrical connectors located on the top and the one solenoid electrical connector located on the side of the transaxle case.Adjust the TR switch. Refer to Adjustments .Install the manual control shift outer lever on the manual control lever and secure with the manual control lever nut. Tighten the nut to 44-64 Nm (33-47 lb ft) .Install air cleaner outlet tube.Connect battery ground cable.
It is on the heating unit on the back facing away from the inside of the car. Not an easy place. Service manual tells you to remove the whole unit to get at it. Which means removing the heating and cooling pipes that enter the back of the car under the heating unit and pulling the heating unit out.
Filters for a Nissan Maxima need to be changed every 15,000 miles. To change it remove the screws, release the retaining clips, and remove the glove box bulb.
* Remove the shift lever knob,console and shift boot * Disconnect the shift and select cables from the shift control assembly * Remove the large shift cable retainer plate and detach the cables from their bracket on the shift control assembly base * Remove the shift control assembly retaining nuts and remove the shift control assembly
You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.
Why would you even want to do it? It would be very costly to change it to a manual system.
To remove a 1993 Nissan maxima rear speakers you will have to remove the seat back, you will need a wrench to remove both of the bolts on each side. The seat will move once done, and then pop the parcel shelf trim. The speakers should come out.
YOUR CAR TAKES ----GEAR OIL---- IF MANUAL TRANS,,NOT AT/FLUID,,,,,THIS IS COMING RIGHT FROM MY HAYNES MANUAL......"""REMOVE THE SPEEDOMETER CABLE DRIVE PINION FROM THE TRANSAXEL ADD LUBRICANT THROUGHT THE OPENING.REINSTALL CABLE PINION"""""...........IT DOES NOT SAY ABOUT FILL LEVELS...........BUDDY MACK
you pull it out you pull it out
1. Remove the front fascia.1. Remove radiator grille. 2. Remove screws on each side of bottom of fascia that attach fascia to bottom of fender protector. Partially remove fender protector. 3. Remove engine underside covers. 4. Remove engine front undercover. 2. Ensure lighting switch is OFF. 3. Disconnect the negative battery cable. 4. Remove the combination lamp mounting bolts. 5. Pull the combination lamp up and toward the front of the vehicle, disconnect connector and remove from vehicle. via Nissan Maxima Owners Manual