I am hoping someone has the answer to this question, as I am trying to remove the chairs from the middle of my 89 Starcraft conversion van.
Swapping the seats is possible. When you remove one of the captains chairs, you'll note there is another set of seat latch hooks in the floor - those are positioned for the bench style. My 2001 came with the bench-style captains chairs with the built-in console - I always wanted to trade with someone who had individual captains chairs... Happen to have gray leather seats? ;)
Pull the pivot handle turn the seat 90 degrees and lift up.
It is hard to remove a steering wheel by hand. A person has to use a steering wheel puller to remove the steering wheel. It applies pressure to the middle with a screw/bolt and it pulls the rest forward.Ê
with a lot of special words.
Sell your Ford junk its not the only problem you will have.
You can rent your chairs for various vendors, and they can even set up and remove the chairs for you. Call the party rental and get all of the prices including set and break down of the chairs in order to get the best rate.
inside of van in vicinity of heater core. to remove, remove battery from engine bay to access bolt that holds it in place
Drop it out of the back, there should be a hole above the bumper on the rear.
should have two holes on both sides where you put the radio removal tools
Need to know how to remove heater fan on 1999 ford e 150 van with small v6 engine
Disconnect the - battery cable Raise and support vehicle Remove wires at top of starter Remove starter mounting bolts Remove starter
Disconnect battery - terminal Raise and secure vehicle if needed Remove 2 or 3 mounting bolts Disconnect wiring Twist and drop to remove
To remove the "key" ignition, insert a small screwdrived in the hole directly below the ignition in the column. You will need to have the key in the ON position otherwise the ignition will not come out of the column.
Behind the bumper remove plastic cover from under rad
You remove the horn button if its in the middle.. Or just remove the plastic in the middle of the steeringwheel. Then take a 24mm i think and unscrew the big nut. Then remove the wheel.
Well I decided to clean my carpet in my truck by removing the front seats. I found out that I have to remove the middle console as well. (Captains seats installed by the way) Well there are some hidden bolts on the inward side of the seat located on the frame under the console....now the question how do I get the console out without damaging it.
If it has one, you simply use the correct size socket and ratchet and turn counterclockwise.
It is in the back, driver's side. It is behind the panel. You have to remove alot of panel but once you get there it is not hard to change,
The fuel filter for the 1991 Ford Econoline Van is under the van on the driver's side just the other side of the frame well. To replace it, remove the plastic clips. Next, remove the filter and replace it with a new one. Do not change the filter when the vehicle is hot because the system will be pressurized and may shoot fuel into your face.
use a socket and breaker bar on the idler wheel to remove slack. remove old belt, follow diagram on panel or hood to install new belt
You need to rent or buy a fan clutch removal tool kit. you need to remove the fan and clutch as one before you can separate the fan from the clutch.
1st you need to remove the horn button. Push down and twist to the left, watch for the spring. Remove the large nut. You then need a steering wheel puller to mount to the wheel hub. If you dont have one buy or borrow one. You can remove the wheel with one person pulling up on the wheel and another resting a drift on the steering shaft and hitting it but I dont recommend this way. It is a "press fit" so after a bit of pulling it will pop loose. Econoline Connection Raleigh NC
Remove Lower Dash Panel passenger side. Remove glove box. Remove middle dash panel (below glove box). ECU is attached to the back of middle dash panel.