Super glue remover officially; however, super glue is quite brittle, and a well-placed tap with a hammer on a flathead screwdriver might work better.
Good luck trying to remove that mount button without breaking the glass. Better off purchasing another mounting button and glue it above or below the original one.
If you are just removing the mirror from the glass, it is usally held on to a windshield button by a small set screw. If not, it is probably held to the button by wedge mounting to the button. The button itself cannot be removed from the glass without breaking the glass. If the button comes unattached, you can reglue the button with a special remount kit sold at auto stores.
should be a very small set screw that uses an Allen wrench
Remove the mirror and use a heat gun to remove the button. Caution: There is always the possibility that the windshield will crack.
I'm trying to repair my rear view mirror on my 1998 Buick Regal but need information on how to remove the button on the mirror attachment.
The small plastic cover in the corner of the window is removable. Mirror mounting fasteners and wiring connections can be removed to remove mirror.
Unscrew the three mounting screws on the underside of the mirror assembly.
* Remove the door trim panel * On power mirrors unplug the electrical connector * Remove the triangler cover over the mirror mounting * Remove the bolts and detach the mirror from the door
(1)Remove the door trim panel; (2)disconnect the electrical connector for the power mirror (3) where necessary, lower the window for access to the mirror mounting nuts (4)remove the mounting nuts and take the mirror out. - Haynes Ford Ranger Pickups Repair manual
* Remove the door trim panel * On power mirrors unplug the electrical connector * Remove the triangular cover over the mirror mounting * Remove the bolts and detach the mirror from the door * Installation is the reverse of removal
* Remove the door trim panel * On power mirrors unplug the electrical connector * Remove the triangular cover over the mirror mounting * Remove the bolts and detach the mirror from the door * Installation is the reverse of removal
Disconnect the- battery cable Raise and support vehicle Disconnect wiring harness at top of starter Remove starter mounting bolts Remove starter