answersLogoWhite

0


Best Answer

unlock the tabs located around the cover and there are two filters inside use care and patience when putting back together it can be tough....

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove the plastic cover on a Mercedes-Benz SL 500 to change air filters?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Will GE MWF Smartwater filters remove sulphur taste?

Yes the GE MWF smartwater filters will remove the sulphur taste. It will remove a lot of stuff from tap water and it will save the environment from plastic bottles


Where is the drain plug on a 2005 Kia Sorento?

remove the big plastic skid plate and it's right there , the filters there but under a fuel line.


Where is the oil drain plug on a 2005 Kia Sorento?

remove the big plastic skid plate and it's right there , the filters there but under a fuel line.


How do you change the in cabin filter on a 2000 Infiniti QX4?

NOTE: Read the complete instructions before beginning this procedure. 1). Remove the glove box pivot pins by pulling up on the handle then sliding them inboard and removing the plastic pivot pins at the bottom of the closed glove box (they may be hard to remove) then open the glove box. 2). To remove the retaining cord, the cord disconnects from the glove box. The glove box end which is a plastic retainer, attached to the cord. UN CLIP THE PLASTIC PIECE FROM GLOVE BOX. 3). Remove the right quarter panel plastic piece that is to the right of the glove box on the floor and between the door. IT IS THE CURVED PLASTIC PIECE. Remove the plastic nut and screw/bolt. Then pull it up and toward the front of the car. 4). Remove the brown plastic piece above the glove box THREE screws. 5). Remove the plastic glove box retaining housing FIVE Screws then remove the housing. IT is behind the glove box door. Set it out of the way. NOTE: You will be able to see and access the blower motor. 6). Just left of center, looking straight at the black blower box, remove the clip holding both cabin filters. 7). Remove the filters together. NEW FILTERS SHOULD COME TWO (2) TO A BOX. 8). Install the new filters in the same hole. THEY INTERLOCK (in the center) and are a small challenge to get them back in. Then re-install the retaining clip holding the lower filter to the air box. NOTE: There is NO clip on the top filter. Replace all components in the reverse order...


Where are the cabin and air filters located in the Lexus RX 300?

Open the glove box. Remove the rectangular black plastic acess panel. Pull the filter out.


How do you change a cabin air filter in Honda 1997 civic LX?

You have to remove the glove compartment to access the filter. Couple of screws and your done These filters are expensive: 25-30 dollars! The installation instructions for the Honda Civic DX, LX, and EX s are in the package when you purchase the cabin air filters. Location of cabin filters: Behind the glove compartment, behind an access door on the passenger side of the vehicle. I just now removed and install the filters on my 2002 Honda Civic LX. Very easy. To remove existing filters: 1. Open the glove compartment and locate and remove the hindge tabs on both sides of the inside of the glove compartment. The tabs are plastic, and pry out very easily. Once you've pried them open, remove each. 2. Just let the glove compartment door swing down. Note: all the contents will fall out. :-) 3. There is a black plastic horizontal door. Open the door, no tools needed, and remove it. 4. Pull out one filter with its plastic frame. 5.Slide the second filter over, and remove it and its frame. 6. Remove the dirty filters from each frame. (Mine were quite dirty.) And replace with clean filters in each frame. 7. Reinstall both filters and frames into the filter housing. 8. Reattach the filter access door. Tilt the glove compartment door up. Replace the hinge tabs on the inside of the glove compartment. 9. Put all of your staff back in the glove compartment. And you're done!


How do you change rear light bulbs in GMC Savana 2500?

You need to remove the plastic above the lens first, then remove taillight. Use a Phillips screwdriver to remove two screws, then use a flat screwdriver to remove plastic rivets for plastic shroud between lens and door. With that shroud off you can see the next nut to remove. Altogether there are about 8 fasteners each side to change the bulbs.


What is the oil filters job in 2001 Ford Taurus?

Directly in centre front of engine, right over the starter.( if you remove this, cover starter with a plastic bag first)


How do you change oil in 1999 Subaru Outback?

remove plastic shroud under engine. remove plug on oil pan.


How do you change overhead light bulb?

The plastic cover will pop off. Then remove bulb.


What are the uses of filters?

To remove impurities


Will hepa filters effective remove pet dander from the air?

Yes hepa filters remove dander as well as dust and pollen