Start by removing the lines, drain the fluids, then remove the pump pulley. After that, remove the mounting bolts.
It is serviced in the power steering reservior.jd
Remove cap to power steering reservoir, add fluid, place cap on reservoir when done.
its located behind the power steering pump...you would have to remove the power steering pump to access it
The library.
in the top of the power steering reservoir on the passenger side of the engine.
where do i put the fluid Its under alternator.
right behind and below the power steering pump on the block.
on the front of the engine and it is run by the serpentine belt.
on the passenger side of the car and it's driven by the serpentine belt.
located on passenger side in back of motor
On the 2004 Monte Carlo you may want to check with the dealer but I believe that this car was equipped with electronic steering assist and does not have a belt driven pump
on the 3.1, it is under power steering pump. remove pump set aside ,do not remove hoses.once removed sensor is reachable!! there should be one bolt to hold sensor in!!