1995-2005 Chevy Cavaliers
How do you remove the pulley of the power steering pump on a 1995 jeep wrangler Rio Grand?
Asked in Power Steering, Pontiac Grand Am
How do you take the power steering pump off a 1999 Pontiac grand am?
How do you remove the steering wheel from a 1997 Grand Marquis?
How do you install a power steering pulley in a 1997 jeep grand Cherokee v 8?
Why would 97 grand prix GTP make noises like it needs power steering fluid but does not the noise does not change with steering it is constant how do you know if belt tensioner or idler pulley is bad?
How do you replace power steering pump 1998 plmouth grand voyager 3.3 l?
How do you replace the power steering pump in a 97 Grand Am 3.1L 6-cylinder engine?
Asked in Jeep Grand Cherokee
How do you remove the belt on a 1994 Jeep Grand Cherokee?
Asked in Power Steering, Water Pumps, Pulleys
Water pump 1997 Grand Prix Got one bolt to take off and it hits the Power steering pulley do you have to take this pulley off to get the water pump off Job was going good till this last bolt?
Asked in Pontiac Bonneville, Pontiac Grand Prix
How do you replace the idler pulley on a 1997 grand prix?
How do you remove replace tensioner on 3.0 liter grand caravan?
First, Disconnect the negative battery terminal from the battery. Then remove the A/C belt. Next remove the serpentine belt. Then remove the idler pulley using a 15mm closed end wrench. Next, remove the bolt securing the tension-er pulley and remove the pulley from the spring base. Next, remove the alternator. Once the alternator is removed you have access to get to the 15mm nut securing the tension-er pulley assembly. Remove the nut and then the spring base. Go in reverse for the assembly.
Asked in Power Steering, Grand Am GT
How do you check the power steering fluid located for a 2001 grand prix?
Asked in Mercury Grand Marquis
How do you remove clock spring for Mercury Grand Marquis?
Asked in Ford Ranger XLT, Grand Am SE, Pulleys
How do you remove the crank shaft pulley on a Grand Am SE?
How do you change the power steering pump on a 98 Grand Cherokee?
if it is like a 97 there are just 2 hoses and 3 bolts to remove. if you are replacing the pulley with a new one dont worry about removing the old pulley. if you are trying to use the old pulley i'd be very carefull on how you try to remove it. It is a plastic pulley with a aluminum hub and the grip ring that the puller fits in breaks off very easily. I would suggest having a dealer shop remove it for you but i'd bet you would want to replace it anyway due to heat weakening the plastic and it breaking on you going down the road like mine did. just use the holes in the pulley to slip your socket through and remove the 3 bolts and it pops right off. good luck with it hope this has helped