answersLogoWhite
Radiators
1995-1999 Dodge & Plymouth Neons
Dodge and Plymouth Neon
DIY Projects

How do you remove the radiator support from a 1997 Dodge Neon?

91011

Top Answer
User Avatar
Wiki User
Answered 2008-01-20 05:48:54

The '95 to '99 Doge and Plymouth Neon's have a radiator support that is held in by spot welds. You can purchase a spot weld removal kit at your local auto body shop, but it is a process. If you have some time on your hands and the tools to weld it back together you'll save alot of money. If you don't have the tools, or the know how, it's better just to pay a shop to do it.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


open the drain at the bottom of the radiator and remove cap


Remove the top and bottom radiator hoses including the transmission fluid, then remove the side mounting bolts, after that is completed, slide the radiator up and out of the engine compartment


Remove the coolant from your 1997 Chevy Malibu radiator. Remove the bottom radiator hose. Run water through the top of the radiator allowing it to run out the bottom.


Theres a drain plug at the bottom of the radiator.. or you can undo the bottom hose..


To remove a radiator from a 1997 Toyota Tacoma the truck needs to be cooled down. The coolant needs to be drained, and loosen the radiator mounts. When everything is loosen remove the radiator.


It is in the front of the radiator area clipped to the radiator support.


The radiator on a 1997 Mercury Mountaineer is removed by draining the coolant, disconnecting the radiator hoses, and unbolting the shroud. The retaining bolts are then removed and the radiator is lifted from the vehicle.




It is on the clear colored plastic coolant reservoir


If it's a 1997 or similar age, jack up the front and remove the bar that holds the radiator up, (you'll have to support the radiator by another means) there's 3 bolts to undo, as well as the 2 electrical connections. There should be enough room to squeeze it past the radiator.


Follow the top radiator hose to the engine. It goes to the thermostat housing. Remove the 2 bolts in the housing and the thermostat is right below it.


The drain plug is located at the lower left rear bottom of the radiator.


Remove the positive battery cable from your 1997 Dodge Grand Caravan battery. Remove the cables from the starter. Remove the retaining bolts from the starter. The starter will come off.


I just replaced the radiator in my 97 SL2 today. What exactly are you asking? Step by step instructions?


It's on the driver's side on the back of the radiator. Difficult to get to unless you partially remove the inner fender well. Easier to remove the lower radiator hose on the passenger side.



how to you remove the spare tire form under the van


How can I remove a power steering pump from a 1997 dodge stratus es


open hood remove the front brace that holds the hood latch from fendre to fender you will see radiator remove the 4 bolts that hold fans to rad 2 on each side remove trans lines and rad hoses lift ac condencer just a little to come off rad clips lift rad out reasmble in rev


Should be in a removable housing at the engine end of the upper radiator hose



The thermostat on a 1997 Ford F-250 is located under the upper hose assembly in the radiator. To locate the thermostat, drain the radiator halfway and remove the hose at the top of the radiator.


facing your truck it should be mounted on the radiator core support to the right of the radiator.


Remove the belt, then remove the bolt holding in the idler pulley.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.