answersLogoWhite

0


Best Answer

Take a look at this website: http://www.carstereoremoval.com/htm/stereoremovalAcuraLegend91_96P.htm I've used this company twice to repair my amps. They are very good. Norm

User Avatar

Wiki User

โˆ™ 2007-01-03 03:13:51
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: How do you remove the radio on a 1992 Acura Legend?
Write your answer...
Submit
Related questions

How do you disable the anti-theft system in a 1992 Acura Legend?

Remove the Anti-theft system fuse.


Your 1992 Acura Legend front brakes wont release?

my Acura legend brakes are fine and Thank you the problem is my interior inside my car looks like dirty and i need to clean it so it will look brand new... I love my 1992 Acura Legend.


1992 Acura Legend?

http://en.wikipedia.org/wiki/Acura_Legend


How do you replace the bulbs in a 1992 Acura Legend instrument cluster?

an acura is an American car and get a new car


What is the Tire size for a 1992 Acura Legend?

205 65 15


Can you use parts from a 1992 Acura Legend on a 1993 Acura Legend?

I do believe it is the same body style and most things should transfer over to the 1993. It may have some electrical differences but not many. You can also transfer parts from a 1994 Acura Legend.


How much horse power does a 1992 Acura Legend have?

I belive it was 260 hp


Why does my 1992 Acura Legend not blow when the heat is on...?

Possibly the Blower Motor has stopped working. This was the case in my 1994 Acura Legend. I just replaced it, and now the heat works great again!


Where is the fuel pump relay located on a 1992 Acura Legend?

i believe it is located in the trunk.


Where is the OBD1 port located on a 1992 Acura Legend?

obd not available until 1996


Need security code for radio 1992 Acura Vigor serial?

yes


How do you change water pump on a 1992 Acura Legend?

Drain the radiator. Remove the drive belt, and the crankshaft sprocket cover. Unbolt the pump, replace it, then re-install the cover and belt.


How much does it cost to fix a heater core to a 1992 acura legend?

havesexwme call 569-8924 banin


How do you find your left radiadtor fan relay?

how do I find the left radiator fan relay for an 1992 acura legend


What causes your 1992 Acura Legend to to rev when im in park?

YOu might have a cracked head gasket- that what caused mine to do that


Where is the radio fuse for a 1992 Acura Vigor?

The fuse box is to the left of the clutch pedal. The radio fuse is in the top row, second from the end (I think).


1992 acura legend makes a clicking sound when you slow down?

check the brakes usually click when pads get thin


What could cause the speedometer to stop working on a 1992 acura legend?

You have a bad Vss Sensor.............. The vehicle speed sensor.


Why would a 1992 Acura Legend cut out at 4000 rpm?

most likely plug wires change them see what happens


How do you remove the car radio in a 1992 Toyota Celica?

How do you replace a 1992 Celica GT antenna


How do you remove factory stereo on a 1992 Acura Vigor?

view website www.cdplayerrepair.com/remtips/vigor_rem.htm


How do you enter a stereo code on a 1992 Acura Legend?

If I remember, turn the stereo on, enter the code using the 6 preset buttons. After the beep, turn the stereo off. Then turn the stereo on and it should be OK. I just pulled my radio to get into the dash.


How do you remove 1992 Acura Vigor rear seat bottom?

The seats on a 1992 Acura Vigor use bracket which are found underneath and behind them. Loosen the bracket bolts to release the seats Pull them off and replace them.


What are the codes to reset the radio after disconnecting the battery on a 1992 Accura Vigor?

Contact the dealer who sold the car when new, and they may have the code on file. Otherwise you will have to remove the radio and write down the serial #. With this number and proof of ownership, any Acura dealer can provide the code.


How do you remove the front seat of a 1992 Acura Legend?

There should be four bolts under the seat, move the seat all the way back then take the front two out than move it all the way forward and remove the back two, after that unhook any wires there are connected