There are about 10 screws that hold the dashboard in place. You will also have to disconnect the wires going to the headlight switch, 4 wheel drive switch, and dc power outlets. The radio is held in place by 2 or 3 screws. A whole lot of work just to remove a radio. GM doesn't want you to do it. I own a 2003 Chevy Trailblazer with the LT package and misc. factory upgrades, it's almost an LTZ, I have a Pioneer Stereo 2 10" subs and a 1000w Kenwood amp. It's 4 screws to remove the factory stereo, however because the stereo unit is connected to the onstar, alarm, etc... it requires a new harness to connect any aftermarket upgrade, also keep in mind that the unit is a 1 1/2 unit so you will have to have an installation kit to install an aftermarket unit unless you find one that fits perfectly. The lower dashboard has to be removed to expose the screws so you can access the trim screws that hold the stereo/ac, trim on. It really is a frustrating bit of work but not too difficult to do. You don't have to remove any knobs or unhook any switches so just ignore the dc power outlets, and switch information the guy above me posted.
how unlock radio on trailblazer 2003
Your 2003 Chevrolet trailblazer radio probably cut though because of a loose or corroded ground wire. The positive wire may also be loose.
how do you set the clock on a 2003 chevrolet trailblazer
I have a 2003 and its 18.7 gal
www.trailvoy.com We have online manuals that contain radio instructions plus many forum areas to ask questions! All run by true enthusiasts!
Chevrolet does not use inertia/reset switches.
Driver side engine block behind the alternator.You need to remove the alternator to get to the sensor.
Chevrolet does not use inertia switches.
The 2003 Chevrolet trailblazer power control module is located in the fuse box. The fuse box is located in the engine compartment.
No - The Trailblazer Envoy Bravada GMT360 platform has a 6x5 bolt pattern.
Begin by removing the radio cover in your 2003 Pontiac. Remove the radio retaining screws. Slide the radio out. Remove the wiring harness and the antenna cable from the back of the radio.
2003 Chevy Silverado 2500HD 6.0l 2004 Chevrolet Trailblazer 2002 Chevrolet Avalanche
remove radio from a grand marquis 2003
Almost 5000 lbs depending upon the 4x4 and power options etc.
The blower motor speed resistor is burned out.
I believe they are 6 - 1/2" speakers.
Value of a 2003 Trailblazer w130,000 miles
The 2003 Chevrolet trailblazer air conditioning line can be found on the air conditioning compressor. The line goes from the compressor to the firewall. The line will go through the firewall to the air conditioner core.
It pulls off. Sometimes easier to remove the headlight assembly to change the bulb. We have instructions at our forum. www.trailvoy.com Trailblazer enthusiasts!
to change brakes on a 2005 trailblazer do i need a star bit to remove cailber pins
pull radio out with coat hanger
Where is the input aux for a 2003 trailblazer
On a 2003 Chevrolet Trailblazer ( yes ) Both the 4.2 litre six cylinder engine and the 5.3 litre V8 engine have a timing CHAIN