Remove engine and transaxle assembly
"How do you replace a factory antenna on a 2002 Toyota Sienna?" I am talking about the whole assembly. Thanks
I assume that it will be like a 1998 Sienna van. There is a sealed bearing in the hub assembly and you change the whole assembly. There are four bolts that hold the hub assembly to the suspension.
How do you remove and replace the motor for the drivers side power window in a 2000 Sienna
The passenger side mirror on a 2001 Toyota Sienna is mounted by screws. To replace the mirror remove the mounting screws and unplug the wire clip.
How to replace a starter in a 2009 toyota sienna
Remove wheelsRemove caliper mounting boltsSlide caliper off rotorRotor should slide off hub assembly
Open the hood, remove the rubber boot, unplug the wire connector, unclasp, remove the burned bulb and replace with the new one.
how do I remove the spare tire from a2007 toyota sienna
You replace 2002 Toyota sienna fuel pump by contacting a person who knows how to replace it efficiently.
3.7 quarts to replace for Toyota sienna.
toyota sienna 2001
To replace the front speakers in a Toyota Sienna the door panels must first be removed. With the door panels removed the speakers will be easily accessible and the mounting screws can be loosen. Unplug the speakers and remove them. Install the new speakers.
Replace the hoist assembly with a good used one from a parts cars in a wrecking yard.
Remove the battery head(+v) for a while, then replace it and star the engine.
how do you remove a toyota sienna 2000 windshield water reservoir tank.
how to replacemotor mount toyota sienna 2004
Lift the car, remove the tire, remove the brake shoe/caliper and remove the old brake pad. Next, put in the new brake pad, replace the brake shoe/caliper, replace the tire and lower the car.
Hey Sid==I think on yours, only the bulb needs changing. Just remove the light assy and change the bulbs in the rear. There are mounting screws to remove and don't unscrew the adjusting screws. Goodluck, Joe This is a sealed beam unit. The bulb alone cannot be replaced. The entire headlight assembly needed to be replaced. First remove the screws holding the turn signal assembly, and then replace remaining screws holding the headlight. It is a bit tricky, but doable. Just replaced both bulbs on my 98 Toyota Sienna XL. First carefully remove plug into the back of the bulb to be replaced. Do not pull the plug out by tugging on the wires, make sure you grab the plug itself. Next, remove the rubber boot protecting the back of the headlamp. You will find a metal clip clamping in the bulb. The clip is designed to be easily released. Remove the bulb and put in the replacement, without touching the glass. I purchased my Sienna in January of 1998. Could there have been a mid-year model change that makes your van different than mine?
No cabin filter available for the 2002 Sienna.
On my 2004 Sienna I have to take out my glove box (it is held in with (2) 10 mm bolt. You have to lay on your head to see the screws. The filter is right behind the glove box after you remove it.
Upon further inspection, the rear door handle assembly on the 2002 Toyota Sienna IS the same as that shown on the Find One Find All website, so never mind.
Depending on the year but most late modles have the bulbs screw in fron the rear. Sometimes you have to remove the light assy .
It should be behind the glove box. Check you owners manual. My 2010 showes me how to replace and remove mine.
The cost of a windshield washer reservoir for a Sienna is 200.00 from Toyota. Copy!