how to remove rear axle from 1988 f250 ford
what is the Torque spec for rear axle hub nut on a 2002 ford explorer
how do you remove the right rear axle on a 1998 ford expedition?
Take rear cover off and losen the 6mm. head bolt. Rotate the gears and remove c-clip from axle. Slide axle out.
how do you replace a Ford F150 rear axle seal
That might be the rear axle, it that is what you want to remove then you will need to remove the rear axle cover drain the fluid and the locate the center pin bolt and remove that in order to remove the center pin to get at axle c-clips then remove the c-clip for the axle you want to remove then slipe the axle out being careful not to distrub the axle bearing
Remove the rear tire and wheel. Remove the axle end cap. Remove the rear wheel seal. Remove the rear wheel bearing. Reverse the process to install the new wheel bearing.
plug is on the left front of axle housing. take a 3/8 drive to remove
First, remove the 8 bolts on the end of the axle (tire end). Next, use a special socket with 4 teeth that fit into the ratcheting nut and remove. The left side is reverse thread! The axle will now slide out easily. Be careful not to damage the rubber o-ring seal around the axle end itself.
loosen up the rear axle nut and loosen up the axle adjusters so the rear wheel moves forward, Now remove rear brake caliper from rear brake caliper mount and the remove rear axle and lower rear wheel and slide belt off rear pully. and remove the rear wheel. http://www.ronincycleparts.com
Answering "What is the wheel bearing torque specs in ftlbs on a Ford 10.5 rear axle on a 2002 F350 Super Duty 4x4 non dually diesel?"
Remove the rear wheel from the axle. Remove the brake pads and hardware. Remove the axle end cap. Remove the bearing. Reverse the process to install the new bearing.
The vehicle needs to be raised and supported by the frame. The u joint at the rear of the driveshaft needs to be removed, as well as the brake lines and abs connections. the rear axle assembly can then be unbolted from the springs and removed.
take the axle out
First, remove the axle. Then, user a large screwdriver or a seal remover to remove the seal. Tap a new seal into place with a hammer. Reinstall the axle and fill the differential lubricant.
Rear you have to change the entire hub assembly Front you have to remove the axle shaft
The axle ratio on a 1969 Ford Mustang axle was 2.75:1
2007 ford focus sedan , rear axle nut , at wheelbearing/ 235 nm --- 174ft/ lb
Remove the rear tire and wheel. Remove the axle end cap. Remove the wheel bearing seal. Remove the wheel bearing. Reverse the process to install the new wheel bearing.
To change the rear axle fluid you can remove the rear cover from the axle and drain it that way. If you don't want to remove the rear cover you can use a pump and a hose to drain it through the fill hole.
The best way to remove the rear axle on a Polaris Hawkeye is to spray it with PB blaster. After waiting several hours or a day, simply pull the axle outward.Ê
front or rear rotor? jack up wheel that needs rotor removed. remove wheel remove brake pads and caliper for back axle, remove axle nut. u will need special socket to remove this nut slide rotor off axle, making sure u dont drop bearings on the ground to remove front rotor on4x4, it is pretty much the same as rear , except you will have to remove locking hub from axle before you can remove axle nut.
You replace it as part of the rear disc assembly. Remove rear wheel and hub nut cover undo hub nut,then remove the rear caliper and pull the disc off the stub axle.