First, raise the rear end of the car,then, remove the tire. Next, remove the center spindle nut.(this holds the hub on the spindle which inside holds the wheel bearing) After removing center nut, pull the hub off of the spindle.(If hub is stuck, its probably due to years and years of rust, in this case, smack sides of hub all around with a BIG hammer until breaks free). Once the hub is off, you will notice the wheel bearing. Be careful with this! The bearing will need to be re-packed with grease before re-assembly. Remove bearing, and proceed to removing brake shoes inside the drum. There will be a few pins and several springs holding it all together. Turn inside of drums before installing new brake shoes.
Will require more specifics, what part you want to fix in the rear brakes?
How do you remove the rear drum brakes on a 1998 ford escort
Remove the 2006 Pontiac Montana wheel and tire. Remove the brake pad Springs. The brake pads will come off. Reverse the process to install the new brake pads.
If the cable aren't frozen. Adjust the rear brakes first. Then if possible, haven't looked at mine in awhile adjust the cables probably under the car
front and rear are disc
The only part that is needed to replace your 1997 Pontiac rear brakes is a break assembly kit. The brake assembly kit will have everything you need.
is it front or rear
You will need to remove the tire and wheel from your 1998 Pontiac Grand Am. Remove the brake assembly spring from the brake pads. The brake pads will come off. Reverse the process to install the new brake pads.
no you do not.
u do it
to remove drums
You need to remove the rear seat to access the speakers and remove the covers.
Front? Rear? What model/year?
Begin by removing the tire and wheel from your 2000 Chevy Lumina. Remove the brake spring and the break caliper. The rear brakes will come off.
18436572..........counter clockwise. Driver side bank front to rear 1357 PS..2468
Disc brakes do not require adjustment like drum brakes. They are self adjusting by design.
Begin by removing the cover from your rear speakers. Remove the rear speaker retaining screws. Remove the wiring harness from the back of the speaker. The rear speakers will come out.
I have a 2000 pontiac grand am gt 3.4 auto trans with rear disc brakes how do i adjust the emergy brakes no adjustment under car how is is done?
The thermostat housing is behind the camshaft sprocket. Remove timing covers and belt then remove camshaft sprocket and then rear timing cover. .
To replace the rear brakes on a Volvo 850 you must first remove the old brakes. Then connect all of the wirings to the new brakes including the brake fluid line and the connection for the brake pads.
bad bearings, probably a pinion bearing
Around $500 for front and rear brakes
There are two horizontal bolts at the front of the cradle, and two verticle bolts at the rear. You do of course have to deal with the engine, transmission, brakes and suspension also.