Auto Parts and Repairs
Toyota Camry
Ford Expedition Eddie Bauer
Ford Expedition XLT

How do you remove the rear door panel on your Toyota Sienna 2000?

464748

Top Answer
User Avatar
Wiki User
2015-07-15 21:36:04
2015-07-15 21:36:04

the lower panel is held on with push on clips, 11 of them that can be "gently pried up" according to the service manual. remove the handle and strap prior to removal.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

how do you remove a toyota sienna 2000 windshield water reservoir tank.

User Avatar

You need to remove the inside door panel, then remove the bolts that secure the mirror. It is very simple procedure.

User Avatar

How do you remove and replace the motor for the drivers side power window in a 2000 Sienna

User Avatar

We have a fix for this problem that anyone can do - includes testimonials! http://www.findonefindall.com/toyota-sienna/index.htm See full details under "How do I replace the passenger side mirror on 2000 Toyota Sienna?

User Avatar

How to replace a starter in a 2009 toyota sienna

User Avatar

1) look to te left of the steering column. 2) notice the coin box 3) remove said coin box 4) fuse panel should now be visible :)

User Avatar

The maximum tosing capacity of the 2003 Toyota Sienna is 2000 lbs..

User Avatar

The fuses for 2000 Toyota Sienna is located in the engine compartment. The fuses are labeled as slot 12 and 13 and are rated at 15 amps.

User Avatar

I was just quoted $2000 (parts and labor) for my 2000 Toyota Sienna, but that was including the pipes before and after the cat conv. Hope that helps. I was just quoted $2000 (parts and labor) for my 2000 Toyota Sienna, but that was including the pipes before and after the cat conv. Hope that helps.

User Avatar

2000 lbs, 3500 lbs with tow package

User Avatar

can you safely drive a 2000 camery with bad sensors

User Avatar

My Toyota Sienna 2000 axle nut measures 30 mm Sprayed the threads as I will be replacing an axle shortly. Probably the same size.

User Avatar

The following link has instructions, diagrams and pictures showing how to make this repair easily and inexpensively: http://www.findonefindall.com/toyota-sienna/siennareardoor.htm

User Avatar

pull the cup holder off by prying it from the bottom, remove the 10mm screw found underneath it, then with the door fully open, pry the panel with a large screwdriver starting from the bottom and working your way up. once the fasteners are pulled away from the door raise up the panel a few inches and pull it out toward the front.

User Avatar

Using a screwdriver, remove the screws from the panel, remove the clips from the panel, and pull the panel away gently. Remove any wiring connectors, and remove the panel from the frame.

User Avatar

Go to this website. It will show how to remove the door panel.

User Avatar

hi please show how do i replace the Toyota seinna 2000 front handle door thanks Andy

User Avatar

stand in front of your van, then left side undernearth, use plier filter wrench to remove the old filter. You can this this filter in kragen or autozone.

User Avatar

Remove the door panel and there should be about 3 nuts/screws holding the mirror on

User Avatar

Passenger side of engine compartment, firewall side of engine.

User Avatar

Inside the gear box located at the bottom on the steering column.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.