Removing the rear brake drums vary little from one vehicle to the next.First,loosen the lugs on the rear wheels,release the hand brake, block the front wheels,jack up the rear and use jackstands.Then remove the rear wheels.Looking at the drum after the wheels have been removed, you will notice two threaded holes one on each side of the axle flange.Give the brake drum a smart rap or two with a plastic mallet or piece of wood and spray the flange w/ WD 40 or brake parts cleaner.Obtain a bolt with the exact size and thread to fit the hole. I found it useful to "borrow" such bolt from around the work area-My favorite is the one fastening a cable or a hoseclamp to the differential.If that don't fit, look around under the hood:there's one there you can use.Thread the bolt into the hole alternating from one hole to the other.The bolt pushes the drum against a flange inside and removes the drum.After work, adjust the star wheel brake adjuster so that the drum turns with hand push with a little drag.
Remove the light assy and screw it in from the rear.
Changing brakes is a pretty simple task. Lift the car, remove the tire, brake shoe/caliper and remove the old pad. Put in the new pad, replace the brake shoe/caliper, put the tire back on and lower the car.
get aoil filter wrench and remove and put new one on.
Remove the water from your 1987 Nissan pickup truck cooling system. Remove the water supply hose. Remove the water return hose. Remove the heater core retaining bolts. Reverse the process to install your new heater core.
To replace the thermostat on a 1987 Nissan pickup, drain the radiator. Locate the thermostat which is under the top hose assembly, and remove the screws holding it in place. Put the new one in position and refill the radiator.
your gonna have to remove trans. and replace the 5 th gear cluster.
is it a pintara
you must take the front grille off to get to the light ,remove 2 screws and fitting on light.
Your best bet is to buy a owners workshop manual It shows all the steps to remove it and install it.
HIT IT WITH A MALLEt
you have to remove the dashboard top. It is located in the right hand side of the dash. It is a little work but you can get it out.
no you do not.
All of the shift linkage should be internal. You will have to remove transmission, split the transmission in two to access the linkage.
On My 93 pickup it , you have to remove the battey and its is just inside the fender. Rick
2001 nissan how do you remove the nissan emblem to access replace broken handle
located and connected to the fan,drain radiator,remove both ,radiator hoses, remove fan belt,remove fan shroud,remove radiator.remove fan,remove water pump.
The lights need to be taken out with a screwdriver Phillips usualy
You must remove the old ones and install new ones. If you have never done it, get a mechanic to do it. If you break a spark plug off in the head, you will never get it out.
disconnect battery and remove,drain radiator.remove top and bottom radiator hose,remove all 3 belts,remove fan shroud,remove fan blade,remove radiator,then remove water pump,when putting back together,replace thermostat.
how to replace a heater core on a 2003 Nissan Altima 2.5
To replace the rear brakes on a Volvo 850 you must first remove the old brakes. Then connect all of the wirings to the new brakes including the brake fluid line and the connection for the brake pads.
remove the negative battery cable for about 30 minutes
Replace wheel cylinders
No, you can replace the grill without removing the radiator.
no u do not