May have to remove rear seats and get in from there
The 1987 Oldsmobile Cutlass Supreme was rated 350 horsepower with the with the V8 engine. It was last year that the Cutlass was a rear wheel drive vehicle.
what is the ratio of gears in a 1986 cutlass
The rear license plate bulbs on a 1996 Olds Cutlass Supreme are replaced by removing the retaining screws, pulling the light assembly out, and disconnecting the wiring harness. The bulb can then be twisted to remove it and a new bulb put in place.
There should be a strap at the rear bottom base of the seats. Pull this strap and tip forward. The seats will lift out.
Equalizer valve not allowing fluid flow to rear?
The low side service port to recharge the AC on a 1997 Olds Cutlass Supreme is at the rear of the engine. It is close to the firewall.
Front = 3 & half, Rear = 4x10
handle at the side
four. Two 4" speakers in the dash, and two 6x9's in the rear. The ones in the dash are really difficult to get to. You have to remove the whole dash. (:
Go to AutoZone.com website and look for repair manual on rear struts for this vehicle. Procedures are listed there for this.
Back seat has to come out and the rear package tray too and then you can get to the bolts that hold the speakers in.
The Oldsmobile Cutlass Supreme was an intermediate-size car produced by GM for the U.S. market. The Supreme sat atop the Cutlass line, beginning as a trim package and eventually becoming its own model name. The popularity of the Cutlass helped drive Oldsmobile to a million sales for the first time in 1978. More than half were Cutlasses. Production of the rear-wheel drive Cutlass ended in 1987. The last car to wear the Cutlass badge was a smaller, front-wheel drive car that left the line on July 2, 1999. It was replaced, indirectly, by the Intrigue.
How do you remove seats in a 2007 Camry SE
fuel filter is located above the rear axle
you have to turn the pistons at the same time you push the pistons in
rear seat will not latch and hold seat in place
Replace wheel cylinders and check rear proportioning valves.
Restoring a classic car or refusing to give one up means finding the right parts. JC Whitney has millions of car parts, including a rear view mirror for a 1973 Oldsmobile Cutlass Supreme.
The heater core on a 1984 Cutlass Supreme is located under the blower motor on the passenger side of the car, under the hood. First you need to remove the blower, and the hoses connecting the heater core. Replace the core, re-attach the hoses, and put the blower motor back on.