answersLogoWhite

0


Best Answer
Copy

try to look on the back inside of the rotor (right where the shaft goes in) and there should be a seal pressed against it. Pry that seal off and you should be able to pull the rotor straight off. If not, make sure that seal is removed and beat and pry the rotor until it comes off. If you have to do this, it is usually means you have a bad inner bearing. The bearing will need to be replaced. Pull it off the shaft with a three jaw puller.

2007-07-31 17:15:27
This answer is:
πŸ€“
🀯
πŸ€”
User Avatar

Add your answer:

Earn +5 pts
Q: How do you remove the rotor on a 1999 ford ranger 4x4 I got everything off and it will not budge. Ford book no help it doesn't show this type of 4x4 front axle and rotor asembly?
Write your answer...
Submit

Related Questions

How do you remove the dash from a 2002 Ford Ranger?

How do your remove the dashboard on a 2000 Ford Ranger?


How do you remove a flywheel from a 1999 ford ranger?

How do you remove the flywheel on a 1999 ford ranger


Do you need to remove the plastic headlight covers to change a turn signal light on a 1997 Buick Regal?

you have to remove the entire head-light/turn-signal assembly to get to the bulbs. There are these plastic clips on either side of the ENTIRE asembly, just pull them up and the entire assembly comes free. Remove the rubber stoppers on the back and then you need to twist the bulb housing to remove it from the asembly. The bulbs themselves just pull out.


How do you replace the front turn signal bulb located on a 1989 Buick Regal?

you have to remove the entire head-light/turn-signal assembly to get to the bulbs. There are these plastic clips on either side of the ENTIRE asembly, just pull them up and the entire assembly comes free. Remove the rubber stoppers on the back and then you need to twist the bulb housing to remove it from the asembly. The bulbs themselves just pull out.


How do I remove the front bumper on a 2003 ford ranger?

Does anyone know how to remove the chrome part of the front bumper on a Ford Ranger XLT


How do you remove starter from a 1998 ford ranger?

you have to go to the car fix to remove it


How remove steering wheel ford ranger?

You can remove the steering will, on your Ford Ranger pickup truck, by removing the steering wheel pin. Remove the wiring harness and the steering wheel will come off.


How do you remove a governor in a 1992 ranger?

Cant Its the computer


How do you remove the brakes on a Ford Ranger?

is it front or rear


How do you remove radio from 1993 Ford Ranger?

with a crowbar


Do you have to remove fan shroud to access thermostat housing on 1997 Ford Ranger?

do you have to remove fan shroud to access thermostat housing on a 1997 2.3L ford ranger


Does the skin remove carbon dioxide?

No it doesnt.


How do you remove a 1999 Ranger transfer case shift motor?

How to peplace A RANGER transfer case SHIFT MOTOR


How to remove Ford Ranger rear window?

How to remove 2000 ford ranger rear window. Need to replace would like to replace with a sliding window need instructions how to do it


How do you remove a 1986 Ford Ranger transmission?

You unscrew the bolts.......


How do you remove ford ranger wheel center cap?

Screwdriver


When winterizing a 2004 ford ranger do you have to loosen or remove the fan?

No


How do change an alternator on 1996 Ford Ranger?

Remove the alternator belt from your 1996 Ford Ranger alternator. Remove the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Reverse the process to install the new alternator.


How do you Remove dome light cover on 1998 ford ranger?

I have a 2000 Ranger, and on mine the lens is made of plastic. To remove it, I squeeze the lens just enough so that the tabs will snap out.


How do you remove Ford Ranger gear knob?

The gear shift knob on a ford Ranger is pressed on tightly. A heat gun or hair dryer can be used to heat the knob to help remove it.


How do you Remove clutch interlock switch on ford ranger?

How to replace a clutch interlock switch on a 1997 Ford Ranger XLT


How do you change rear tail light bulb in 1998 Chevy Blazer?

remove all the screws from the tail light asembly turn bulb to remove put electrical contact greas on new bulb install new bulb replace screws


How do you remove the door panels in a 1987 Ford Ranger?

To remove the door panels in a 1987 Ford Ranger, simply crank the cover on the door to pry it open. Then remove the head screws inside and take off the other three screws.


Why doesnt my Cigarette lighter wont work on 1998 mustang?

You have to check your fuse for the lighter...if that doesnt work pep boys or autozone has a little to that they touch it with to see if it has any power if not then you might have to remove your dash to make sure wires are not rubbing or that everything is connected and plugged right


How do you replace the rad hoses on a 1996 Ford Ranger?

How do I remove air from the cooling system of a 95 ford ranger 4 cyl