Seat Belts and Safety Systems
Chevy Silverado
Dodge Ram
Grand Am SE

How do you remove the seat belt on the drivers side of a 1988 Dodge Ram?

192021

Top Answer
User Avatar
Wiki User
Answered
2008-10-09 03:47:06
2008-10-09 03:47:06

take out bolts and lift, common sense really

001
๐Ÿ˜‚
0
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Related Questions


All you have to do is loosen the acessory that is driven by that belt. There is an anchor bolt and a pivot bolt that need to be loosened then the belt will slip off. Of course if the belt is "under" another belt, then you will have to remove that belt as well.


Drain the water from your 1988 Dodge Ram cooling system. Remove the water pump belt. Remove the water return hose. Remove the water pump retaining bolts. Reverse the process to install your new water pump.


use a ratchet to pull be on the belt tensioner to loosen slack then remove the belt



The 1988 Chevrolet S 10 pickup truck driver seatbelt is anchored to the floor of the vehicle. The anchor can be found behind the drivers seat. Remove the seat belt anchor retaining bolts.



Remove the belt, then remove the bolt holding in the idler pulley.


Drivers side of the frame under the truck


The belt tensioner is rotated clock wise with a 15 mm wrench or belt tool.


remove front of engine and remove timing belt It runs the pump


Remove belt. Remove the bolt and then pull the pulley off. Put new pulley in position. Put the belt back on.


Remove the drivers side wheel. Remove the inner cover. Taking an Allen wrench and tighten the tension roller against the belt.


depending on the style of belt, on the alternator belt there is an adjustment just below the slider holding the alternator, you just simply tighten it until belt becomes tight.


You remove the upper timing belt cover and look at the belt while cranking the engine over.You remove the upper timing belt cover and look at the belt while cranking the engine over.


You have to unscrew the tensioner bolt and remove the serpentine belt first, then change the pulley and replace the belt.


you first have to remove your serpintne belt but i thought there was only one belt on that neon try that drive safe


Take pressure off belt tensioner and belt should slide off pulleys


You can remove the old serpentine belt on your 2004 Dodge Ram by loosening the tensioner pulley. Put the new serpentine belt on and tighten it with the tensioner pulley.


Yes. and you have to remove the belt that runs alternator-power steering etc before you can remove the air conditioning belt.


It is inside the front of the engine, it is driven by the timing belt.


you need to remove or loosen belt tensioner assist bolt that is attached to the top of the alternator


REMOVE THE TOP MOTORMOUNT .TO ALLOW THE ENGINE TO COME UP WITH A SUITABLE JACK UNDER MOTOR REMOVE THE SERPENTIN BELT .. AND THEN REMOVE 15MM BOLT ON TENSIONER ...TO INSTALL NEW TENSIONER ,.


Remove the wiring harness from your 1999 Dodge Caravan alternator. Remove the alternator belt. Remove the alternator retaining bolts. Reverse the process to install the new alternator.


remove the right hand side wheel and fender liner to access the serpentine belt


BIG JOB Get a manual on your car if you want to try it.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.