there should be a 10mm bolt that holds a bracket that holds the front seat down. under the pass seat. It is located in the center of the bike.
Open up both front doors and remove everything from the front seat to the firewall, no kidding.
Level 99 in clumsy ninja is currently the maximum level in this game.
Yes, just pull up the seat cushion on both sides and pull out .
According to bike shop the 1999 ninja has about 115 hp. the ninja 600 platform hasn't changed that dramatically as far as specs in the last 10 years I'm sure this is an accurate figure plus or minus 5 hp or so an easier way to compare bikes is to use the torque ratings because most manufactures provided this on their spec sheets. http://www.bikeshop.ro/motorcycles/motorcycle-selling-clasified-add-second-hand-kawasaki-ninja%20600-from-1999-104838.html this guy has no clue what he's talking about lol, bikes haven't changed in ten years? lol well apparently he's never actually owned one or ever heard of fuel injection, aluminum perimeter frames, or probably helmets for that matter. there is no way that a 99 600 was pushing out those kind of ponies, actual is around 95-99 rwhp on a 99 zx6r with about 40ftlbs of torque, and 116rwhp on an 06 zx6r (636cc)with 52.5ftlbs of torque, and 110 rwhp on an 06 zx6rr (599cc) with 49ftlbs of torque.
1
in the pasanger back seat there is the seat please remobe it and you will see the hole spot when you c an remove with 10 mm sockets and thas the pump
99
first you lift a back seat and take off, second you need a screw drive for take off a 3 screws and lift a other part (back seat part) .
how to remove oil pump for 99 vw passat.
'96 Explorer Seat Belt Replacementhttp://www.seatcoverset.com/seatcovers-car_seat_cover.htmIn order to replace the driver side seat belt on a '96 Explorer, you must completely remove the drivers seat. Removing driver side seat belt: Use a 10mm socket/wrench to remove the two bolts securing the front of the seat to the floor. Move the seat as close to the steering wheel as possible to expose the rear of the sliding seat rails. Pop off the two covers at the end of each rail to expose two more 10mm bolts securing the seat to the floor. Next, remove the plastic cover with a Torx symbol on it at the rear of the seat belt guide rail. Removing the aforementioned cover will allow access to a large Torx bolt just below the rear of the center console. Remove this large Torx bolt, unplug any electrical wires below the seat, and remove the entire seat from the Explorer. With the seat out, you can use the same Torx wrench to unscrew the seat belt itself from the seat. Reassembly is the opposite of disassembly.
99% sure enough to say... No, no airbags in the seat.
The fuel pump is located under the back seat . Remove the four screws and you will see the wires. You will have to diconnect them at the coupling. Then it should be an easy replcement.