4 nuts under the dash around the brake pedal
You Must remove the trans to access the slave... on the 5 speed for sure.
Yes , the slave cylinder for a HYDRAULIC clutch is inside the manual transmission bellhousing. It slides over the transmission input shaft and is bolted to the transmission
you just replace it
The Ford F150 was produced from the years 1948 to present in the United States. The cylinder 8 in a 2002 F150 4.6 is located against the driver side firewall.
you need to be more specific on year model there are a few different designs that all remove differently
remove lifters from a 1999 ford f150
if its a standard/manual truck. slave cylinder would be located on the firewall next to the brake booster, and would take standard dot 3 brake fluid.
Yes , the slave cylinder for your hydraulic clutch is inside the manual transmission bell housing. It slides over the input shaft to the transmission and is bolted in place inside the transmission . To CHANGE the slave cylinder the transmission has to be removed , but the lines to the slave cylinder CAN BE BLEAD from a fitting that extends outside of the transmission bellhousing
How do you remove the inside door panel on a 2002 ford F150 supercrew?
how do you remove the old carburetor form a 1984 ford f150 4.9
It pull's off and snaps back on.
The temperature gauge sensor on the 2002 F150 is located on the driver's side of the vehicle and under the intake. This is almost impossible to remove without removing the intake itself.