answersLogoWhite

0


Best Answer

I would think it would be the same as my 99, if so the starter is located on the passenger side of the engine below the intake manifold., there is 2 bolts one on top and one on bottom the bolts screw through th engine flange and into the transmission. Don't foget to disconnect the battery first. Also don't forget to hook your ground back up before you put your bottom bolt back in, the bottom bolt goes through the ground connector.

User Avatar

Wiki User

โˆ™ 2015-07-15 19:55:28
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: How do you remove the starter from a 1997 Nissan pickup 4 cylinder when the Hayes manua only says 'remove starter'?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you change the starter in a 1992 Nissan SE Frontier pickup 6 cylinder?

disconnect neg.cable,then disconnect pos. cable from starter ,then other wire,then remove 2 bolts holding starter to engine.


How do you replace the starter on a 1988 Chevy pickup 8 cylinder?

Disconnect the - battery cable Raise and support the vehicle Remove wiring at the top of starter Remove mounting bolts Remove starter


How do you take out a starter on a 1988 Nissan pickup with a v6 engine?

remove neg.cable.then positive cable cable from starter,remove male to female wire ,then remove 2 bolts holding starter to engine.


How do you remove starter 1988 Nissan pickup with v6?

go to auto zone.com enter vehicle info.then look up starter,then click on repair guide and it will tell you.


How do you get to the top bolt to remove your starter on a 1993 Nissan truck 4 cylinder?

by going over the top of the bell housing


How do you replace the starter on a 1995 Nissan pickup automatic 4 cylinder?

disconnect neg. battery cable, remove positive cable from starter,use 12 mm wrench,disconnect other wire, u need no wrench,male to female fitting ,then get 14 mm wrenchand remove 2 bolts holding starter on to engine. that's it.


How do you get a starter out of a 95 Nissan Hard body pickup XE?

disconnect your battery. disconnect the cable(s) on the starter. remove bolts from starter. pull starter out from bellhousing. enjoy life as you know it. eat crackers and tacos.


How do you replace starter in 1996 Nissan 4WD pickup?

remove negative battery cable,jack up truck and remove front passenger tire,easier to get to,its next to oil filter,remove ignition wire from starter,remove positive battery cable from starter,remove 2 bolts holding starter on to engine,remove starter,installation is same as installing.g0ood luck.


How do you remove and install a starter in a 1995 Nissan Pathfinder?

Remove the positive cable from your 1995 Nissan Pathfinder battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.


How do you remove a starter on a 1991 Nissan Pathfiner?

must remove oil filter to get starter out have fun


How do you diagnose a starter or ignition problem on a Nissan Altima?

Take the steering column housing off (usually held by 4 screws from the bottom) and remove the starter cap from the back of the ignition cylinder. In a Nissan, the ignition cylinder usually has a T shaped pin which turns the starter. if you can start your vehicle by turning the starter cap with a screw driver, you probably don't have an issue with the starter.


How do you replace starter on 1988 Chevy 1500 pickup?

Remove the positive battery cable from your 1988 Chevrolet 1500 pickup truck battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.

People also asked