It's kindof tricky i just put a new starter in my 1986 2.0 cavalier rs your going to want some wheel ramps it's hard to work where the starter is located without them anyway in the very front bottom of the motor is the starter mine was in a tight spot the exaust pipe went around mine you will have some wires running from the seloniod and battery make sure that you don't get them mixed up there are two main bolts 15 mm i think and another going into a bracket at the other end disconnect the wiring pull the two main bolts and the bracket it's going to be a pain working around the exaust pipe I think there is a couple other wires you will have to disconnect to one is the ground wire that bolts onto the motor if your car don't start after installing the new starter clean up the connecter with some sand paper after pulling the starter out check the teeth on the new starter there supposed to line up a certain way or it will defenetly decrease the life of your new starter theres usually directions with a new starter if your putting in a usedone the best thing i can say is the starter teeth should have two teeth around the one tooth on the gear of the engine another thing to is you will probibly haveto put shims in with the starter your installing they come with a new starterif the starter your putting in is used keep the old shim from your old starterthe shim fits between the starter and engine where the two main bolts go in.
good luck i installed mine without any wheel ramps there was hardly any clearenceif you want head room get some ramps
The starter for a 1994 Chevy Cavalier is on the side of the engine at the rear. Always disconnect the battery before attempting to remove the starter.
Disconnect the positive cable from your 2003 Chevy Cavalier battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
Remove the positive cable from your 1998 Chevy Cavalier battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.
unbolt it
Disconnect the - battery terminal Raise and support vehicle if necessary remove wiring from top of starter Remove mounting bolts Remove starter
Disconnect the - battery terminal Raise and support vehicle if needed Disconnect the wiring harness at the top of the starter Remove starter mounting bolts Remove starter
It is attached to the starter.
Disconnect the - battery cable Raise and support the vehicle Remove wiring at the top of starter Remove mounting bolts Remove starter
It is bolted to top of starter.
Where is the stater located on a Chevy Cavalier located?
i would like to remove the backseat from my 1992 chevy cavalier
The 1997 Chevy Cavalier starter bolt size is 9/16 by 3.5" inches long. You will need three starter bolts to secure the starter.