answersLogoWhite
Auto Parts and Repairs
Starters and Ignition Systems
VW Vanagon
Classic 1964-1978 Ford Mustangs

How do you remove the starter on a 93 Geo Prizm 1.6L?

353637

Top Answer
User Avatar
Wiki User
2015-07-15 19:09:27
2015-07-15 19:09:27

This starter is directly under the fuel injector bar. It is virtually impossible to remove it from below but because you can touch it, that is a temptation. Don't try it! You are going to have to remove the fuel rail to get that starter out. Different shops quote varying prices but I opted for Pep Boys at $ 89.00 plus tax (and that included the rebuilt starter).

1

Related Questions

User Avatar

Disconnect thre neg battery cable then the starter wires. Takeout the mounting bolts and remove it.

User Avatar

Look here: How do you change the starter on a 1996 Toyota Corolla?Prizm and Corolla engines are the same.

User Avatar

Here is the link to ehow on how to remove the CV joint on a 1991 Prizm. http://www.ehow.com/how_7906772_replace-geo-metro-cv-joints.html

User Avatar

The signal for the starter originates from the key switch, I would start there.

User Avatar

Geo Prizm was created in 1989.

User Avatar

My 1991 Geo Prizm LSI does not have overdrive My 1991 Geo Prizm LSI does not have overdrive

User Avatar

Geo Prizm is compatible with the Toyota Corolla.

User Avatar

Disconnect the ground cable from your battery, remove the bolts holding the old one on and then take the wires loose and put the new one in.

User Avatar

disconnect battery or connection to starter and take it off.

User Avatar

How can find vin geo prizm cevrolet 1994?

User Avatar

Remove the old mount & replace with the new.

User Avatar

i had 1991 geo prizm but i want to know what color memory wire??

User Avatar

belt diagram for a 1996 Geo Prizm

User Avatar

where is the vacuum diagram located on 1995 geo prizm

User Avatar

Remove the cables from the starter. Remove the three retaining bolts from the starter. The starter will come out. Reverse the process to install the new starter.

User Avatar

Make sure the starter is getting voltage. If it is, perhaps the starter is bad. If it isn't, maybe your ignition switch is shot.

User Avatar

First you look and try to jump it if it rumbles its the allternater

User Avatar

how much cost to change a clutch for a geo prizm 1995

User Avatar

where is located the oil pressure switch for 94 geo prizm

User Avatar

what transmission will fit in a 3 speed 1990 geo prizm

User Avatar

How do you replace the timing belt on a 1994 Geo Prizm 1.6?

User Avatar

Geo Prizm door handles are the same 1993-1997


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.