Buick Century
Toyota Sequoia
Ford Explorer XLT

How do you remove the stereo from a 1993 Buick Century?

111213

Top Answer
User Avatar
Wiki User
Answered
2008-07-06 23:18:44
2008-07-06 23:18:44

1)remove the instrument panel trim plate

2)remove the radio retaining screws( 2 on top 2 on bottom)

3) pull the radio out far enough to access the antenna cable

4) unplug the antenna cable from the back of the radio

5)unplug the electrical connectors from the radio by depressing tabs

6) remove the radio from the dash

7) installation is the reverse of removal

if you have the delco loc 2 anti theft feature, make sure you know the code for your radio before you remove or it will scramble and not work. Also, you should always disconnect the battery cable before working on the radio/electrical system

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Replace ignition switch for 1993 buick century?

Remove the tire, brake caliber and the rotor should side off the hub.

Center of the steering wheel.

The spark plug gap for a 1993 Buick Century is: .045 for the 4 cyl 2.2 engine .060 for the V6 3.3 engine

Remove the fuel tank to gain access to it.

When the radio was installed in the 1993 Le Sabre, something was bumped or disconnected. You will have to remove the radio then check the system to see what the problem is.

Remove the crossmember and drop it out the bottom no problem.

remove your the cover off the door panel to get to the stero.make sure u unplug it

There is a sticker on the inside of the trunk lid that has that information.

Underneath the car, inside the fuel tank.

Between passenger front wheel and water pump

it is distributorless no cap to replace has coil packs

The easiest way to disable your 1993 Buick factory alarm is to remove the alarm fuse. The alarm fuse can be found in the fuse box.

you first have to locate the screws that hold down the faux wood cover over the stereo located at the bottom of the panel. then remove the panel and locate the screws that hold down the stereo itself. remove those and the stereo will become loose. be careful not to pull the stereo or let it drop after you loosen the screws because the stereo is still wired up. gl.

the Century first joined the Buick lineup in the late 1930s to emphasize the car's advertised top speed of 100 mph. Without modification that has remained the top speed of the stock vehicle.

Jack and safely support right front side of car disconnect battery remove 2 bolts that support starter remove wires from starter solenoid slide starter out of housing reverse to install

Quad-Drive module or QUAD-DRIVE No.1 error

the catilatic converters could be stopped up.

The easiest way to bypass the 1993 Buick factory alarm is to remove the factory alarm fuse. The factory alarm fuse can be found in the fuse box.

Located in fuel tank - remove tank to access


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.