Nissan Pathfinder
Nissan Stanza
Toyota Sequoia
Ford Explorer XLT

How do you remove the stereo in a 92 Nissan Stanza?


Top Answer
User Avatar
Wiki User
2006-03-06 21:19:45
2006-03-06 21:19:45

The molding around the dash area where the stereo has several hidden screws up under the cross pieces. Remove those and it should pop off. From there the stereo has 4 screws that hold it in place.


Related Questions

90-92 Stanza have 4x114.3 bolt pattern

how do you remove a distributor rotor on a 92 Nissan sentra

The Nissan stanza has a 4-speed auto transmission. It shifting is electronically-operated . The transmission computer box is located in the center console. It is next to the ECM box.

no, take right wheel well cover off it will be looking at you..

it is the s shaped pipe running from the down pipe of the exhaust right near the manifold,to the egr valve

i just typed in 92 Nissan stanza in Google and about three down their is one that says body kits. they only sell one its 600.00 dollars but its pretty nice I would check and accessories category

Call an egineerer haha or remove the plastic cover around the stereo and the screws are easily accessible and if you don't want your stereo email me at thanks

remove the cup holder and ashtray assemly ther are two small screws facing upwards remove them and it will come out There're more! Unplug the light of the trash tray, remove tray. Loosen two upward BOLTs at the back. Draw the stereo partially, then fully remove the bolts with hand. Afterwards, remove the stereo.

Use the clock on the aftermarket stereo that you should buy. My clock on my 92 always gets off so i just use the clock on my stereo.


go to,look up 92 Nissan stanza,engine size and look up clutch slave cylinder,then to the right of screen ,look up repair guide and it will show and tell you how to.answerunscrew the pipe fluid line unscrew bolts,remove ,apply some good grease on the end ball of the cylinder install new one,bleed the system slowwly verry well

ya might just be low on oil ...My 92 Stanza has a bad valve cover gasket that leaks and when the oil drops to 1 & 1/2 quarts low the valves start ta clatter. After adding oil it took a few miles of easy driving ta get rid of the noise.

I had your same problem 30 years ago on the same car same year every thing. you need to hit it with a hammer until it catches fire then pull it out with your teeth.

== == I had the same problem with my 92 Nissan Stanza XE. Turns out it was the starter. You might need to look into getting a new starter. Also, have someone check your spark plugs, plug wires, and your fuel pump. I say fuel pump because after we fixed the starter problem. The fuel pump went bad. These are great cars, you just have to take a little extra care of them.

You;ll need an injector removal socket from Kent Moore or a Snap-on dealer.

The ecu on a 92 Celica is located behind the stereo bolted to the floor under the airbag controler

how to remove the starter from a 92 s-10 4x2 with a 2.8 engine

How do you remove the stuts rear from ford crown victoria 92?

Not sure if the 92 is the same as the 91, but on the 91 you need to loosen the adjusting idler on the alternator on top and the a/c idler from the bottom. remove the a/c belt & install the alt. belt, make sure your route is correct between the two guide as the belt goes up to the idler... hope that helps.

Begin by removing the wiring harness from your 1992 Nissan antenna. Remove the antenna retaining nuts. Reverse the process to install your new antenna.

bend over an i ll show you bioch

Inside the transmission under the pan.

check both of your pulleys,they have marks on them.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.