REMOVE FUSE COVER ASHTRAY AND LITER AND THEN REMOVE TWO SCREWS ONE THE TOP OF THE PANEL HOUSEING AND TWO SCREWS ON THE UNDERNEATH INSIDE IF THE ASH TRAY AND IF INSPECTED FROM UNDERNEATH PRESS BACK THE TABS AND STEREO IS OUT
to add to previous answer after removing the top fuse panel and removing screws you have to remove the cup holder and there should be a couple of extra screws. the cup holder is a pain to remove but with a little persistence it can be done.
Pop off fuse cover. Remove two outer screws: these are the top two of four screws holding the top of the wrapping middle front fascia on, to which the radio assembly is attached. Next remove the little drawer, cigarrette lighter, and ashtray. Next, some models have a cupholder and others have simply a fascia where the cupholder *should* be. The fascia can be removed by pulling straight outwards with some force (careful not to damage your interior surfaces). Then remove the two screws on either side of the cupholder/fascia. After that is removed you finally have access to the two lower screws holding the bottom of the wrapping middle front fascia on (these are just behind and above the screws for the cupholder/fascia). Once these are loose and the two plastic clips nearby are squished inwards the whole wrap-around fascia + radio assembly can be removed together. Careful on the edges as the channels for the vents come with this part & these vehicles are now old enough that the foam/glue surrounding these vents can easily tear/break off.
Found this site http://tarago.blogspot.com/ that contains lots of pictures and a step by step guide. Really helpful for me.
Get a Haynes manual - there's a lot of stuff to take off
The cover surrounding the stereo just clips on, give it a good pull toward you and it will pop off, the stereo will be right there...
I would advise you to check out the Previa site on yahoo. It is an excellent site. Check this site it out http://tarago.blogspot.com/ , it helped a lot.
On the panel I think it says radio
Remove the plastic panel, remove the bolts, disconnect the wires from the back of the stereo and remove
Toyota Previa was created in 1990.
with difficulty
how to replace a heater matrix in a toyota previa
yes
remove the radiator, then remove 4 screws that holds the fan ,,done..
yes, you have. And change new seal too.
remove the radio.and once outside remove the tape deck wich is screw to te radio.