1) Open the glove box and remove 5 screws. I think 9/32" screws.2) Remove side panels from driver side dash and passengers side dash, and extract 1 screw from each side.3) Remove 1 Phillips head screw at top center of air vent.4) Extract 2 screws under vent panel, carefully remove top dash.5) Extract 3 screws from the top of the front dash panel, disconnect and remove radio.
Remove the belt from your 2004 Chevy Cavalier alternator. Remove the alternator wiring harness. Remove the alternator retaining bolts. Reverse the process to install your new alternator.
What sequence is used to remove radio from 2004 sububan
You don't. This is regulated by the BCM.
You must remove the fuel tank.
How to remove the factory radio and disconnect wirring harnes in a 2004 f150 ford truck
Remove the decorative cover to the radio. Remove the radio retaining screws. Pull the radio out and remove the wiring harness. Remove the radio antenna cable. Reverse the process to install the new radio.
The tire pressure for the stock 195/65 R15 tires on a 2004 Chevrolet Cavalier is 30 psi. This is the pressure when the tires are cold.
panels by the airvents
Remove the fuel line from your 2004 Chevy Cavalier fuel tank. Remove the front fuel tank retaining strap. Push upward on the back of the fuel tank, until all of the fuel this drained out.
2004 Chevy Cavalier windshield washer fluid reservoir retaining bolts. Remove the windshield washer fluid supply tube. The windshield washer fluid reservoir will come free.
How do I remove the dash on a 2004 Suzuki Grand Vitara 4wd to get to the radio wires?
how do you replace thermostat for 2004 cavalier
Remove transmission oil pan for access to filter
I have a 2004 Malibu and trying to remove the radio/defrost control console
Pull out on the little black piece at the same time as the coax itself. It will feel like it is going to break, but it will come out.
Check out this site... http://www.logjamelectronics.com/piefrd04aux.html
yes.. because also the security system can get screwy if you get rid of the stock.. my freind ran hers to under the passengers side seat.. you can do whatever.. but keeping the stock radio in will really help you..
Remove the Phillips-head screw behind the bag clip to the right and below the radio. The bezel is then held in place with friction clips. Just pull to remove.
Salvage yard or through the dealership
It will If you willing to do the work the radio harness is different and the radio trim bezel changed in 2003 so you would have to make it work.
1. Carefully pry radio dash trim bezel outward, disconnect all harnesses from back of bezel and remove bezel 2. Remove the (4) 9/32 screws securing the factory radio to the sub-dash 3. Pull radio forward, disconnect all harnesses and antenna lead and remove radio