How do you remove the supercharger and replace with stock parts on a 1995 Buick supercharger?
The best way to replace shocks and struts on a 2001 Buick Park Avenue Ultra is to follow the owner's manual instructions. The parts can be purchased at most local auto parts stores such as Auto Zone. Remove the old parts and refer to the manual to install the new parts.
you can go to zzperformance.com click on a grand prix and see all of your L67 parts
Cannot get hands or fingers in to remove replace bulbs do i need to remove any parts to get bulbs out?
cannot get fingers or hands in to remove replace headlight bulbs do i need to remove other parts to do this on a 1998 Honda civic?
Most of the time a supercharger is not replacing anything. You are just adding on extra parts, like a fuel pump, larger fuel injectors, brackets, etc. However with roots or twin screw type superchargers you actually are replacing the whole top of the manifold, since the supercharger bolts on top of their own manifold.
No; your parts store guy will direct you here.
1st remove belt you will need a power steering pulley puller can rent from your local parts store follow instructions supplied with puller finally reinstall belt
no repair.... must replace.... $10 US at any parts store
On average how much would it cost to replace the brake pads and rotors on a 1992 custom Buick Lesabre?
It is important to know the cost of replace the parts of a car while owning it. The average cost to replace brake pads and rotors to a 1992 Buick LeSabre as a kit would be about $300.
Just replace the bent hinges along with the new hood. Salvage yard is a good source for these parts.
Kit available at auto parts w/instructions
Your local auto parts store can sell you a tool to remove them and replace them safely.
Supercharger oil for a 1993 Ford Thunderbird can be found at auto parts stores that sell racing performance parts. Usually, a 50 wt. oil will work for this type of engine.
Get a manual on your car from the parts store and make sure your engine has a belt. It depends on what engine you have.
One can purchase replacement Buick parts from many retailers. Replacement parts can be purchased from Buick, from auto parts retailers, and from other people via the internet.
Is there a parts interchangeability list for buick lesabre
YOU HAVE TO REMOVE THE STEERING WHEEL,IT,S NOT HARD TO DO BUT THERE IS ALOT OF SMALL PARTS IN THERE. FIRST YOU WILL NEED A PULLER TO GET THE WHEEL OFF. I WOULD GET SOMEONE WHO KNOWS HOW TO DO THIS,BUT IF YOU REALLY FEEL THAT YOU CAN DO IT GO SLOW AND DON'T JUST START PULLING PARTS OUT WITHOUT LOOKING,BEING CAREFUL IS THE HARD PART. GOOD LUCK PAUL G
It's in the middle of the dash on top. Not sure yet how to remove it, just checked with the parts dept at a buick dealer. Cost approx $62.00 part only.
located at the end of the upper radiator hose. remove two bolts, replace with new parts remember to replace the gasket.
You should by a service manual from the parts store where you get the water pump for step by step instructions and photographs.
once you remove the break caliper and brake shoe holder, you have to remove 3 bolts from the inside. I think they are 15mm You also will need a 33mm socket to remove the big nut on the axle. Don't forget to unhook the ABS connector if you have ABS. Reassemble and make sure you get torque specifications from your dealer or auto parts store when you purchase the replacement hub. This takes about 1.5… Read More
Find it under the car in the fuel line and it takes special tools available at the parts store.
from underneath the vehicle u have to remove some suspension parts and parts of the front cover of the engine
How do you remove the manual window handle from the rear door panel of a 1990 Buick Century you can't see the clip?
Your local auto parts store will have a inexpensive tool you can buy that will remove the clip with a little practice.
Remove and apply 12V directly to input Bring to an auto parts store that is equipped to test for load and drag
There should be 2 bolts holding the old one on. Remove them and replace it with a new on from a parts store.
Cannot get fingers or hand in to remove replace headlight bulbs on a 1998 Honda civic do you need to remove any other parts to do this?
Have someone with smaller hands to do it for you.
Does the intake manifold on a 1997 buick century have to be removed in order to replace the camshaft position senson?
No it does not. Go to a parts store and buy a Haynes Manual that is specific to your car.
Remove the float from the Regal. inspect the float for leaks, then check the spring and needle valve as it could be stuck. If all parts are ok then the parts need cleaning as they are sticking.
Get a manual from a parts store and it has pictures and all.
How can the Clutch peddle moving parts be lubricated and with what lubricant.
On a 1995 Buick LeSabre can you replace fuel pump without removing tank parts house said look under back seat for inspection plate?
I was told by the person at the Auto Parts store that I could go through the back seat on our Buick Lesabre to replace the fuel pump. That is simply not true, this past weekend I replaced the pump, and you must drop the fuel tank. I hope this helps anyone else that was told the same as I.
Not USUALLY...in most vehicles, you remove the thermostat housing and gasket, replace them. (With lubricant) An easy job and not expensive! How this helps!
Standard labor time to remove and replace the transimssion without transfer of parts on a 1999 Chrysler LHS is 5.1 hours, with complete transfer of parts, it's 5.7 hours.
It is not an easy job. Get a manual on your car from the parts store or AUTOBOOKSONLINE.COM.
Just remove the old bulb and take it to an auto parts store. They can then sell you the correct one.
Remove everything on top of the intake (hoses, fuel rails, linkages.) Unbolt the manifold and remove it. Clean the old gasket off and replace it. Reinstall all parts removed to get to the gasket.
On the 3.0L the air cleaner box is in the way. Other than that all you have to remove is the plug wires.
For pads only, remove single caliper bolt and rotate the caliper away/off the rotor as it will pivot on the anchor bolt on other end. Pads will easily pop off. Caliper piston is a screw design and will need tool from auto parts store. hope this helps!
I own a 1999 Buick Century and I believe any 1998-2003 Century or Regal will work on most parts. Try looking for Buick Regal parts, same stuff, easier to find.
You can purchase an ignition coil, including coil pack, for a Buick LeSabre online, through automotive supply dealers, or at your certified Buick dealership auto shop. The price for the parts alone will run around $40 to $45. Then, you will have to add in the labor costs, which vary depending on your mechanic.
It will cost more to fix than the gun is worth. The safety is basically two parts: safety spring and Safety. 1. remove Left grip 2. replace spring if needed. 3 replace safety. Parts came be had at Numrich Gun Parts Corporation.
This all really depends on the car it is going on and how much boost you are seeking to produce. The most common parts are: * Supercharger Head Unit * Supercharger manifold or bracket * pulleys * belt * FMU or Fuel Injectors * By Pass Valve * Fuel Pump or Boost a Pump * Boost retard box, ECU reflash, or hand held programmer Here is also a link that explains it more: www.superchargersonline.com/content.asp?ID=85
How do you remove and replace an ECM on a 1989 S10 and how do you remove the dash section to get it out?
You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.
Remove the plastic cover if your car still has it installed and remove the bolts holding the covers on and remove, the drivers side is a pain, you may have to remove other parts so they can be removed.
Remove the mower deck. Remove the phillips head screw at the end of the shaft underneath the mower. The releases your shaft from the bootom of mower. Remove steering wheel and remove shaft. Replace parts as needed.
Possibly in the Parts department of a Buick dealership or at a large auto parts store.
You'll have to take the seat mechanism apart to determine what the cause is then repair or replace parts as needed.
Hi Buick auto parts are made in USA and Canada. Recently I had bought one Honda bike and for the safety I bought all the parts of it from various suppliers
When you need to replace the battery in your Viper remote starter, you a screwdriver and new battery. Open the fob using the screwdriver by inserting it in the grove to pry the two parts open. Locate the battery and remove it, then replace it with the new one. Put the two parts of the fob back together.
The parts dept at a GM dealership can print you one.