Lower tailgate and remove two screws. Pull assembly to the rear and it will release.
Unscrew the grey pannel off of the talilight assembly to gain access to the light bulbs, then the bulbs remove from the pannel by simply pulling them out.
The tail light is an assembly. The lens does not come off separately. The assembly is removed by lowering the tail gate, removing two screws, and pulling lamp rearward.
you have to remove the headlight assembly 3little bolts
From outside,take a screws out to get light assembly loose and remove light socket from back of assembly and channge your light bulb,then put it back.
you have to remove it from the outside.after you remove the screws press the bulb and turn it to the left to remove.
To fix a license plate light on a 1995 Dodge Colt you must first remove the screws holding the light cover in place. Remove the light from the bumper completely. Remove the license plate light bulb from its socket and replace with a new bulb. Place the light assembly back in its place in the bumper. Secure the light assembly in place with the screws you removed.
in the trunk there are 3 plastic wing nuts take them off and the light will come out.
On my 2005 Dodge Ram Daytona. I had to open the tail gate, remove the two screws on the jam next to the light assembly. After removing the assembly, there is a light bar held by six screws. After removal of these, you can select the bulb you wish to change and then reassemble to install light assembly.
on all dodge trucks the way you change the bulbs is simply unscerew the tail light assembly and remove it from the rear of the vehicle and you will see your lightbulb fittings right on the back of the light assembly
Open the tailgate, notice the two small screws on the side of the tail light assembly, remove the two screws and you can then wiggle the tail light assembly out to expose the sockets and wiring.
Open the tail gate, remove two small screws that hold the tail light assembly in place, wiggle the tail light assembly out, twist out socket and replace the bulb.
From inside the trunk you remove the three or four finger nuts to remove the entire taillight assembly. Once you get it removed you'll see the light plugs on the backside.