http://www.edmunds.com/ownership/howto/articles/45308/article.html
Thank goodness I found this article. It tells you exactly how to do it and with pictures I might add...
GOOD LUCK!!!
I believe it unbolts/unscrews from the inside. If you're changing a bulb, I think that can also be done from the inside, WITHOUT removing the outside lenses.
I have a 2000 Ranger, and on mine the lens is made of plastic. To remove it, I squeeze the lens just enough so that the tabs will snap out.
How do your remove the dashboard on a 2000 Ford Ranger?
Jack up the 2000 ranger. Remove the wheel and brake caliper. slide the rotor off. Take off the axle nut dust cover and remove the cotter pin. Remove the nut, and slide the assembly off. Change the bearings and races, then reassemble.
Inside the trunk there is a trim panel that needs to be removed that covers up the taillight bolts. Remove the trim panel and then you can remove the two bolts that hold in the taillight. I have also included an instructional video that will show you how this is done. Hope this helps, 1ATony
remove two screws, remove tail light, remove bulb. reinstallation is the reverse of removal.
On a 2000 Ford Ranger , 4.0 liter EFI , V6 engine : The PCV valve is on the drivers side engine valve cover , on the top of the valve cover , near the REAR of the cover
Drop the tailgate and look at the side of the lens for screws.
Dust cover on what?
remove right valve cover on cadilac sts
You can't remove it because it does not have a governor. The speed is computer controlled.
How to remove 2000 ford ranger rear window. Need to replace would like to replace with a sliding window need instructions how to do it
Remove the old bulb and look on it's side. The # is listed there.