Best Answer

The timing belt has to be removed to access the water pump. Once the pump is replaced the timing belt has to be replaced and set.

User Avatar

Wiki User

โˆ™ 2015-07-15 21:16:18
This answer is:
User Avatar

Add your answer:

Earn +5 pts
Q: How do you remove the water pump on a 1987 Toyota Camry?
Write your answer...

Related Questions

How do you make carburetor adjustments on a 1987 Toyota Camry?

The 1987 Toyota Camry does not have a carburetor. It is fuel injected.

How much engine oil does a 1987 Toyota Camry take?

A 1987 Toyota Camry will take 5 quarts of oil. The type of oil the Camry uses is 10 W 30.

Where is the location the fuel pump on Toyota Camry station wagon?

Where is the location of the fuel pump on a 1987 toyota camry wagon

How do you change the front speakers in a 1987 Toyota Camry?

== ==

Where can i find a manual to a 1987 Toyota Camry?

Where is the fuel pump on a 1987 Toyota Camry?

The Fuel Pump Is In The Fuel Tank. You Have To Remove The Fuel Tank To Access It. The Wires Are Blue + and White -...

Were is fuel pump 1987 Camry Toyota?

The fuel pump is located in the tank.

Where is the fuel tank located in 1987 Toyota Camry wagon?

The fuel tank on the 1987 Toyota Camry wagon is located on the underside towards the back of the vehicle. You will find that the fuel tank lies directly under the backseat.

How do you take apart the dashboard to get at the speakers on a 1987 Toyota Camry?

remove the glove box to start with because it hides a couple of the bolts you need to remove, then unbolt the entire lower dash assembly and remove it(both driver and passenger side).

Does my 1991 Toyota Camry 2.5 V6 use a timing belt or chain?

All Toyota Camry 2 1987-1991 too the V6 GXi<3 using a Timing Belt...

What broke when my 1987 Toyota Camry had no oil in it?

There is no way to know without tearing the engine apart.

How many gallons of fuel does a 1987 Camry hold?

The 1987 Toyota Camry has a 13.5 gallon fuel tank. There were many complains of fuel leaks and fuel vapors associated with this gas tank.

What parts are needed to tune-up a 1987 Toyota Camry LE?

que partes necesito pera hacer el tune up a un Toyota acmry 1987

Where is radiator drain on Toyota 1987 Camry?

It must be at bottom of the radiator, you should a valve responsible for drainage.

Spark plug gap 1990 Camry 4-cylinder?

The spark plug gap for 1987-1991 Toyota Camry: 2.0L, 4-Cylinder is 0.044.

Where is the thermostat located on a 1987 Toyota Camry?

I did an 88 recently. facing the engine it is on the left. Follow the hose from the radiator.

Where is the ignition control module on a 1987 Toyota Camry?

It Is Behind The Glove Compartment...It Should Have A Blue Wiring Harness Conector.

What size are the wiper blades on a 1987 Toyota Camry?

Left (drivers side) 19". Right (pass side) 17".

Is the 4 cylinder engine on a 1987 Camry noninterference?

Is the 4 cylinder engine on a 1987 Camry noninterference?" Is the 4 cylinder engine on a 1987 Camry noninterference?"

How do you replace the tail light relay on Toyota Camry?

In a 1987 Toyota Camry (I think through like 1992), it's in the panel to the left of the driver's feet. There are two relays in that panel on mine, the rear is the Defogger, the Front one is the Taillight relay.

How do you change spark plugs on 1987 Toyota Camry LE?

I need to know also. I can't get the spark plug wires off!

Where is the park neutral switch on a 1987 Toyota Camry?

on '88 Camry 4-cyl, Neutral Safety Switch is in front, just behind radiator, on transaxle case. For an87 and better data, ask question with name of component, as above. good luck.Answerhow to tell whether my 1987 Toyota camary motor is locked up

To find a store to buy a carburetor for Toyota Camry 1987?

You have to call one of Toyota dealers, usually stores don't sell such parts. Also you might want to check

What would cause a 1987 Toyota Camry to have intermittent heating issues even after back flushing the cooling system?

Check the condition of your heater core.

How do you remove water pump from 1987 laser?

Drain the water from the cooling system. Remove the water hose from the water pump. Remove the belt from the water pump. Remove the water pump retaining bolts.