answersLogoWhite
Auto Parts and Repairs
Dodge Dakota
Door Panels and Handles
DIY Projects

How do you remove the window crank of a 2003 Dodge Dakota?

575859

Top Answer
User Avatar
Wiki User
2015-07-15 19:57:47
2015-07-15 19:57:47

door handle removal tool any auto part store in HELP section

1

Related Questions

User Avatar

Pull out the U-clip located on the base of the window crank.

User Avatar

Pop back the plastic cover from the center of the crank and remove Allen or Philips screw. Handle will then pull off.

User Avatar

push in on the door pannel by the crank and remove the snap ring behind the pivit point

User Avatar

Their is a special tool to remove manual crank window cranks and it will work for almost any car. You can pick one up at auto zone

User Avatar

I was working on the same problem for about 2 hours and discovered a metal clip in between the crank and the washer behind it. Just use a small flathead screwdriver, wedge it between the washer and crank and try to remove the metal clip. It should pop right off

User Avatar

Dodge Dakota V6's didn't have a crank sensor until 1992.

User Avatar

Remove the inside door panel of your 1997 Chevy Lumina. Remove the linkage to the window crank. Remove the window crank retaining bolts. Reverse the process to install the new window crank.

User Avatar

You will need to remove the inside door panel of your 1977 Chevrolet blazer. Remove the window crank linkage. Remove the window crank retaining bolts. Reverse the process to install the new window crank.

User Avatar

Remove the inside door panel. Remove the Allen screw from the window crank linkage. The window crank handles should come off.

User Avatar

Pry the screwdriver between the door panel and the window crank base. Remove the metal clip slowly and carefully. Pull the base of crank to remove it.

User Avatar

remove the clip retaining crank to the regulator shaft, this requires a special tool available at most parts houses.

User Avatar

How to Remove or Install Car Window Crank Handles check related link below

User Avatar

You need to remove the window hand crank with a window hand crank removal tool.

User Avatar

To replace the window crank handle on the 1993 Geo Prism, first remove the interior door panel. Then, access the screw that holds the window crank in place and remove it. You can then remove the handle itself.

User Avatar

you can buy a window crank removal tool at an autoparts store that pulls the little pin off to remove it.

User Avatar

To remove the window crank on the 1992 Toyota Paseo, first pry off the interior door panel. Then, access the screw that holds the crank in place. Remove the screw and the handle will come loose.

User Avatar

most crank sensors are for engine timing with the cam shaft, the distributor on at least 97' dodge and newer controls fuel timing.

User Avatar

Remove inside door handle and window crank handle, remove inside door panel, remove vent window and channel assembly, remove window.

User Avatar

You can remove the window crank handle by just using a simple shop rag. How you do this you slide the rag(unfolded) between the door panel and window crank and rotate around the window crank until you snag the clip that is retain the window crank. The clip is a simple wire clip shaped like a "C" To reinstall you place the clip back in the groove on window crank and press back on the window regualtor shaft

User Avatar

If the crank sensor is not working, the engine will not run.

User Avatar

You have to remove the inside panel, where the window crank is, or would be.

User Avatar

Your local auto parts store can sell you a very inexpensive tool to remove the clip that holds in the window crank handle. It should be under $10.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.