This is a job of extreme difficulty/skill level and should only be done be experienced technicians. The transmission cooling lines need to be disconnected. The transmission then needs to be supported. The transmission mount can be disconnected followed by the bell housing bolts which fasten the assembly to the engine. The drive shaft can then be dropped. Lastly the bell housing bolts can be removed allowing the assembly to be lowered.?æ
Remove the u-joint from the back of the transmission. Remove the transmission mount bolts. Remove the transmission bolts. Remove the linkage. The transmission will slide backwards and can be removed.
This varies but basically you remove the drive shaft, wiring and linkages. Unbolt the mounts and from the engine and kick it and falls on the ground.
Begin by removing the wiring harness from your 2000 Pontiac Grand Prix transmission pressure solenoid. Remove the solenoid retaining screws. Reverse the process to install your new transmission pressure solenoid.
No. The transmission is completely sealed.
sealed system or not
Dexron III automatic Transmission fluid should be used in a 2000 Pontiac Grand AM. This can be picked up at almost any general store.
how do you remove dash from a 2000 Pontiac grand prix se
Remove the transmission oil pan
just remove it
You unscrew the screws
Unfortunately there isn't one.
4T65-E 4-speed automatic transmission
Read the tag on the transmission.
when you remove the back seats on a 2000 Pontiac grand am SE if you look threw the trunk there will be a string that you pull that will fold the seats down and at the bottom there will be two latches to remove seats