If it is the serpentine belt then you will need to remove the passenger front tire and the plastic cowling in the engine side of the wheel well. using a 13mm box end wrench you will need to rotate the tensioner located just above the camshaft pully towards the back of the engine. THis is not an easy access but can be done. Wrap the belt according to the manual and turn the tensioner until the new belt can slip over the camshaft pulley. There is very little play so this requires some patience and strength. Good Luck
Ford Contour was created in 1995.
The curb weight of a 1995 Ford Contour is 2769 pounds.
Locate pcv valve on 1995 ford contour
TAke the bolts soose that hold it on. It is an assembly.
It depends on what you want to fix.
The transmission plug on a 1995 Ford Contour is located on the side of the pan. It allows for fluid to be quickly drained during maintenance.
Yes , a 1995 Ford Contour should have a heater core . It is used to warm the air ( if necessary ) that comes in to the passenger compartment of the vehicle
In the fuel tank
The ( 1996 ) Ford Contour has a ( 14.5 U.S. gallon / 55.0 litre gas tank )
The Ford Contour was produced from the years 1995 to 2000. The front pump transmission seal in a 1998 Ford Contour is located very close to the camshaft.
They are available online. Do a google search for "Contour wiring diagram".
I was looking at fordparts.com and for the 1995 Ford Contour 2.0 liter four cylinder it shows ( Motorcraft RT-1150 , a 190 * F thermostat )
if the 1995 ford contour is not running (transmission or engine is bad )a good price for it is $ 75 and they have to come to you and pick up the car.
According to one of Fords websites : For a 1995 Ford Contour , 2.5 litre V6 engine : ( the spark plugsare gapped at.054 inch )
Sorry to say I have a 95 ford contour as well. 1995 was the year they switched from the bad stuff r-12 to slightly less bad stuff 134a. If your sticker is still on the unit it'll tell you which type it is, if the sticker is off... well you should take it to an A/C repair shop and have them tell you. (My sticker was off and I had r-12)
have you checked the fuses?
40 to 60 psi
broken motor mount
go to the wreckers get a new one
2002 ford crown Victoria how to repair crank sensor?
Goto autozone .com and look in repair info