you never gave me the answer.....
I need to replace my outside handle on the drivers door. Toyota told me to go on line to see a diagram. But, where? It is a 2000 camry.
= outside door handle on a 1997 Toyota Camry. =
I have a 2000 Toyota camery that the drivers door handle on the outside broke - not an easy job, the door must be taken a part, and there are screws you don't see that must be taken out so the handle come out. Do yourself a favor, take it to a mechanic who knows Toyota cars, or you will end up with more problems then just a handle.
To replace the broken handle you will first need to remove the broken piece using a screwdriver. Once the broken handle is removed place the new one in it's place and screw in.
You have to take the inside door panel off and behind it you can see where the inside door handle is connected.Usually to a rod that opens the door.Either the hande has become disconnected or tghe rod is broken or bent.
Need to know if it is an inside or outside door handle.
How to Do It - 2012 How to Replace Outside Car Door Handle Toyota 1-10 was released on: USA: 27 May 2013
with a screwdriver
Replacing the door handle on a 1997 Toyota Camry is easy with the proper tools chief among which is your check book. Start by going to the nearest Toyota dealer. The rest will fall readily into place.
Remove the inside door panel and replace the outside handle. If the outside handle is limp, the arm that attaches to the rod that connects to the lock has probably broken off.
Drivers side, below E-Brake handle, facing downward.
its the keyless entry
you have to take the door panel off the inside first
Seperate valve for outside faucet turned off, broken valve stem inside of outside faucet or handle stripped at faucet.
You can get a replacement handle that slides over the broken shaft and is held in place with a set screw. Most auto part stores have them. I first saw them at Auto Zone.then you should get a new one
go to the website autorepair.about.com and they have the step-by-step instructions. good luck!
go thru passenger side and open drivers door; remove inside of door panel. You will see wire rod unhooked next to left side. rehook rood and outside should wook. If this is not the problem then the outside door handle has broken and must be replaced by taking two nuts/bolts (don't remember now) from inside, unhook rod, and replace handle.
Two tools needed, 1) hammer 2) chisel Next, slide the chisel into the door handle Then repeatly use the hammer to chip the door handle away.
If its the cables inside you need to remove the panels and replace the cables. You can in a pinch just disconnect them from the handle. Then pull them to release the door.
just go to a junk yard and remove the panel on one of the cars there it's very easy pull two nuts and unscrew panel from door i just did it and was shocked on how easy it was
Remove the inside door panel of your 1994 Chevy Lumina. Remove the door handle linkage. Remove the door handle retaining bolts. Reverse the process to install the new door handle.
from the inside. take your door panel off and look around in there. the door handle is usually held on with pop rivets that have to be cut off from the inside of the door.
The problem is that the inside door handle is broken. Although the inside door handle needs replacement you can still open the door by pulling on the lock lever above the handle.