First remove the door panel, 4 screws and a little prying and its off. There are Five rivets that need to be drilled out. Two are easy and you will see which ones are the two. The Three others are backwards. I had to drill on the soft alluminum and then take a pair of dykes and snip at it until I got the rivets out. It took me about an hour to get all five out.
I suggest buying the motor and regulator together, much easier to mess with. If you didn't then you must drill out three more small rivets and then place the old regulator on to the new motor. I taped the regulator to the bracket because I didn't want the angle to change. Then I used the supplied bolts and placed the regulator and bracket to the motor. Once it's on remove the tape.
Now, back to the rivets that are a pain. You will notice that the rivets that are backwards are also a mounting stud. I had to use a small drill bit from the back side and drill it out so that I had a clean hole. You have to do this on all 4 studs. Then find some small bolts, nuts and washers and bolt it back up. Make sure you put the regulator back on it's track for the window.
You should be up and running. I have pics but it's pretty easy.
You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.
How do you replace the blower motor on a 1994 chevy lumina euro?
the beretta and lumina motors are about the same i have a lumina motor in my 95 beretta
Wire, Switch, Motor, window regulator.
Behind the dang motor
i don know how would a monkey fix it
I need instructions on how to change the window motor in 1995 Chevy Camaro.
Right next to the blower motor
what is the spark plug gap for a 98 Chevy lumina sedan 3.1Liter engine
Remove the inside door panel of your 2002 Chevy Cavalier. Remove the window motor wiring harness. Remove the window motor linkage. Remove the window motor retaining bolts. Reverse the process to install the new window motor.
There are four motor mounts located on a 1990 Chevy Lumina. Two on either side of the engine. One the rear and one in front of the engine.
how to repair a window motor on a 380sl mercedes
How to repair electric windows depends on what is wrong with them. If the motor that runs the window has burned out then replace the motor. If the switch is faulty then replace the switch. Check for broken wires, repair them if found.
Remove the wiring harness from the back of your 1998 Chevy Lumina heater motor. Remove the heater motor retaining bolts. Remove the fan from the front of the heater motor. Reverse the process to install the new heater.
yes, same motor
First test to see if the problem is the switch, wiring, or the motor. Here's howhttp://www.ricksfreeautorepairadvice.com/repair-topics/window-power-repair/test-power-window-motor-and-regulatorThen replace the regulator if the switch and wiring test good. Here's howhttp://www.ricksfreeautorepairadvice.com/repair-topics/window-power-repair/replace-a-power-window-motor-regulator
how to fix a window motor for a 92 plymoth acclaim
the blower motor for a 92 lumina is under the dash on the passenger side...my husband had to change the motor in out car a few months back.... right under the glove box
Show me you how to install window motor for 1992 Chevy camaro
if you dont have any oil in the cars motor that would be a reasin why its knocking
I have a 96 Chevy Blazer S-10 and the latch to open the window in the back hatch will not work. How do I replace the motor?? or whatever to repair?
Begin by removing the 1994 Chevy passenger side door panel. Remove the window motor wiring harness. Remove the window motor linkage. Remove the window motor retaining bolts. Reverse the process to install the new window motor.
You don't. These are sealed units and are not serviceable (nobody sells internal repair parts for them) . When they break, you remove and pitch them, then install a new regulator gearmotor assembly.
replace rear window wiper motor on 2001 Chevy venture