Chevy Blazer
Chevy S-10
Chevy Blazer S-10

How do you repair a throttle cable for 1993 Chevy S10 blazer?

123

Top Answer
User Avatar
Wiki User
Answered
2012-06-28 16:09:19
2012-06-28 16:09:19

Replace it with a new one, there is no repairing it.

001
๐Ÿ˜‚
0
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Related Questions


It is on the throttle plate right across from the throttle cable.


It is on the side of the throttle body opposite the throttle cable.


On the throttle body, opposite side of the throttle cable.


It is located on the throttle body, opposite side the throttle cable connects.


It's on the throttle body, opposite side of the throttle cable.


The 1997 Chevy Blazer shifter cable will have swivel nuts on each end of the cable. Connect the shifter cable and turn the swivel nuts to the right to install the shifter cable.


I believe that the first digital cluster on a S-10 Blazer was in 1989.


The cable that runs from the throttle body to the transmission is the detent cable. The other cable is the speedometer cable.


The T V cable is a "Throttle Valve" cable and is located by the throttle body and is part of the throttle and can be adjusted by simply pushing on the adjustment part of the TV....by adjusting the cable it will affect the shift points of your trans.


It is located on the throttle body, opposite side of where the throttle cable is attached.


It is located on the side of the throttle body, opposite side where the throttle cable connects.


The TPS (throttle position sensor) would be found on the throttle body, opposite side the throttle cable is attached to.



throttle position sensor is located on the throttle body oposite of the throttle cable. Should be held on by 2 screw and a 3 wire plug.


The 1996 Chevrolet Blazer shifting cable will have a retaining nut on each end of the cable. Loosen the retaining nuts. Remove the cable routing retainers. Reverse the process to install the new cable.


The tps is on the driver's side of the throttle body. The throttle body is mounted to the front of the intake, and has a cable going to it from the throttle pedal. When you push the pedal down the cable opens the valve inside the body.


The TPS sensor is mounted on the throttle shaft on the opposite end of where the cable attaches.


Check for a vacuum leak or sticking butterfly valve at the throttle body, or possibly a sticking throttle linkage or throttle cable.


This vehicle has an electronic throttle setup, aka "Drive by Wire." So therfore there is no cable to grease.


The throttle cable is located on top of the throttle body.


It is attached to the starter. The positive battery cable runs directly to it.


The throttle cable is not adjustable.


A push-pull throttle is a very misunderstood thing. It is a dual cable throttle operation where in the pull cable is what opens the throttle plates. And, the push cable along with a throttle return spring is what closes the throttle plates.


If you are looking for the throttle position sensor, it is located at one end of the throttle plate shaft, on the side of the throttle body, opposite side to where the throttle cable is attached.


The throttle cable does not go from the transmission to the throttle body.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.