Take out the side indicator light assembly (which is most difficult part) and then replace the bulb.
You have to remove the console cover. This starts with two screws in the console storage tray.
STEP 1: Remove the console topOpen the console arm-rest and remove the two bolts near the latch.Lift the console from the now un-bolted end and carefully pry up from opposite end (there are 4-6 tensioning-pins holding the remainder of console top.BE CAREFUL - you have a plug in the console top for the traction control.Lift up the console top and adjust it out of the way.STEP 2: Remove the shifter position indicatorIf you're REALLY god at working in small spaces, you MIGHT be able to remove the bulb socket from the shift indicator without removing it, but realize you have to turn/twist the bulb socket about 90 degrees and then pull down.The bulb is on the driver's side of the shift indicator. Remove the indicator by removing four bolts and lifting up slightly to gain access. Twist the bulb out of the indicator module, replace bulb, and return bulb socket into the shift indicator.Turn ignition key on to assure the new bulb is working properly.STEP 3: Reassemble the consolePlace the shift indicator module back in place and put in the four bolts.Set the console top tension-pins into place and press back down working from dash-end back to console glovebox compartment.Insert the two console-top bolts back in at latch area of console glovebox.DONE!
what need to do when indicator light is on
It means you have 2 different problems. There is a problem with the SRS and the ABS. Neither of which I would ever recommend a novice attempt to repair. Take it to a professional for repair of these systems.
The iPod touch does not have an indicator light, only a screen.
The third generation iPod shuffle has the indicator light on the top Êclose by the earphone port. This indicator light tells you about the battery charge status.Ê
If you have an automatic transmission. Then you do not have a shift indicator light.
We need to know which indicator light you speak of.
Run a diagnostic test to find out why the computer turned on the MIL (malfunction indicator light), repair whatever is wrong and the light should go off.
Malfunction Indicator Light
The indicator light is on because your car is having a problem. This light is to let you know that you need to have something in your car repaired.
how do you replace shift indicator light escalade 2003
Go to this link. It's really simple. Take about 10 minutes. http://volvospeed.com/Repair/SV70console.php
What does 'service engine soon' light mean on a 1998 olds intrigue?
A malfunction indicator light is also known as a check engine light. It is a light on the dashboard of a car that goes on when there is a problem with the car's engine.
The brake indicator light is for the EMERGENCY break, release this break.
You have a turn signal light-bulb out .
The GED indicator light is an warning indicator. Essentially, it means that the alternator in the vehicle is not charging properly.
alternator is probably not charging. you need to fix this NOW. new alternator is likely the only repair.
remove neg batteries cable for 15 seconds
I have the same problem. The dealer says to forget it because it costs a small fortune to repair.
By having a professional repair the problem that has turned the light on. They will reset the light after the repair. This is not a DIY repair.
the gas light is the light right under the gas gauge. it is a yellow light that comes on, just a circle!
SYMPTOMS Three lights flash red on the Ring of Light (RoL) on the front of your Xbox 360...Three lights flash red on the Ring of Light (RoL) on the front of your Xbox 360 console. The upper-right quadrant light is the only light that does not flash red.You will see the following indicator on the front panel of your Xbox 360 console, which will repeatedly flash on and off:Collapse this imageExpand this imageBack to the topThe three flashing red lights may indicate that there is a hardware problem with your Xbox 360 console. Back to the topIf you are experiencing this problem, you can submit a console-repair request online. However, before you submit your request, first try the following two steps to verify the problem: # When you turn on the console, look at the light on the power supply. The power supply light should illuminate green even if the three lights on the Ring of Light flash red. If the power supply light is not green, please follow the steps in one of the following Microsoft Knowledge Base articles: 906101 (http://support.microsoft.com/kb/906101/ ) Troubleshooting your Xbox 360 Power Supply when the light is red906102 (http://support.microsoft.com/kb/906102/ ) Troubleshooting your Xbox 360 Power Supply when the light is orange906103 (http://support.microsoft.com/kb/906103/ ) Troubleshooting your Xbox 360 Power Supply when the light is not illuminated # Turn off the console. Wait 10 seconds, and then turn on the console again to see whether the problem re-occurs. Back to the topIf the steps in the previous section did not resolve your issue, your console may have to be repaired. For more information about how to start the online repair process, please visit one of the following Web Page links: United States customers - Online console repair (http://support.xbox.com/support/en/us/nxe/LiveIDSignIn.aspx? redirectUrl=http://support.xbox.com/support/en/us/nxe/registerdevice.aspx? step=repair)Outside the United States - Online console repair (http://www.xbox.com/support/)Note: Online console repair service is currently not available in all countries and regions. For more information about how to contact Xbox Customer Support directly, please visit the following Microsoft Web site: http://www.xbox.com/support/contact (http://www.xbox.com/support/contact)Back to the top---- APPLIES TO * Microsoft XBox 360 Video Game System * Microsoft Xbox 360 Hard Drive (20 GB) * Microsoft Xbox