HOW DO YOU USE A SLIM JIM FOR A 2004 GMC CANYON TO UNLOCK THE DOORS?
The driver door does not unlock the power locks for a few reasons. This motor could be burned out or the wires could not be attached correctly.
You need to use the red master key to unlock the door, if you are using a black chipped key it is not fully programmed into te driver door lcok
the only way we have found to reset the security was too lock the driver door, then using your key, unlock the driver door. repeat as ness. the only way we have found to reset the security was too lock the driver door, then using your key, unlock the driver door. repeat as ness.
use your key to unlock the driver door and manually unlock the right back door
This is by design. It's done to help prevent you getting car jacked by someone jumping in the passenger door This might be normal. I have two cars, one requires a key and the other can use a wireless key. With the key I turn once to unlock the driver door, then turn a second time to unlock passenger door. With the wireless I push butten once to unlock driver door and push a second time to unlock all other doors.
put key in driver door and unlock...
push door open on remote, or unlock driver door with key.
you can lock the driver side door on my 2001 ford explorer sport but it wont unlock with key nor key pad you have to go through passanger door
To repair a stuck driver-side manual window, use a screwdriver to remove the screws attached to the door panel. Pull the door handle away from the door and lower the window regulator to the lowest possible position.
If you are referring to your power door lock on the driver's door, I know that on my 1995 Explorer XLT, in the jack storage compartment there are relays for driver door unlock/all door unlock/all door lock/ and two more relays for interior lamps and trailer park lamps.
what is wrong with the door latch? will it not open/latch? what year is the vehicle? all of these are needed to answer your question.
Press the " U " on the lock/unlock switch located on either the driver or passenger door.
you have top use the factory remote or unlock the driver door with the key.
Unlock the driver door with the key.
Follow in order: -remove key from steering column -close all doors -open driver door -insert key in steering lock -repeat the following 3 times in 24 secs: -turn key to on then back to lock -push driver side door switch 3 times -check that door lock and unlocks-if not wait 40 secs -if lock and unlock-push any button twice -check that door locks and unlocks-if not push driver side door switch -if lock and unlock-push any button twice -check that door locks and unlocks-if not push driver side door switch -if lock and unlock-push any button twice -check that door locks and unlocks-if not push driver switch -if lock and unlock-the end. -remote should work after this.
first you may not have a door actuator in the driver door i found that in the hard way wile a friend of mine and i was installing a car alarm i found that i never had a driver side actuator second maybe your door actuator went south
My 94 Jeep Grand Cherokee has the issue that if I lock all the doors with the automatic lock. I can't unlock the door on the driver side with the key without the Security Alarm going off. To resolve this issue, I have to go to the passenger side, unlock the door there with the key, then go around to the driver side and open the door on the driver side with the key.
REPLACE PASSANGER DOOR LOCK MODULE. SOMETIMES YOU MIGHT NEED BOTH PASSANGER AND DRIVER DOOR LOCK MODULES. THEY ARE ABOUT $250 EACH. YEAH I DID IT IN MINE.
It is important to know how to open and lock the doors of an owned vehicle. There is a master lock on the driver side door, that can be used to lock and unlock all the doors.
The fuse for the power door lock relays is in the fuse panel ( # 18 ) The relays for driver unlock , all unlock , and all lock ( if it is the same as the 4 door ) are in the jack storage compartment .
First unlock and open the hatch, the horn alarm is now disarmed and you can unlock the driver side door.
Remove door panel for access and investigation
You put the key in the driver door and turn to the unlock position.