They are built with a high density foam and a ratchet assembly is molded into the foam. They can't be fixed without destroying them. Better off just replacing them with one from a scrap yard or a dealer.
I have a 2002 Sedona - after opening the drivers door turn your side lights back on you can then close and lock your car with the side lights on. Hope this helps.
how to repair drivers side manual window for 2002 jeep liberty sport
Has the power window lock switch on the drivers door armrest been switched on ?
On the drivers door armrest has the window lock switch been pressed on the left side ? If it has , then only the drivers door switches operate the power windows . Press the right side of the window lock switch
How do you repair drivers side door latch mechanism on 98 GMC extended cab pickup?
Replace driver's switch assembly
if is not the windsheild is there a drain over there ?
First... get a repair manual. Follow the instructions...
Type your answer here... If you can get just the armrestcover you can put it on yourself, its not that hard. Run the back of the seat tilted forward toward the steering wheel. There is a plastic track at the bottom of the seat back that can be undone, allowing you to reach up inside the seat. Look up where the armrest is and you will see a retintion clip on the armrest shaft. Use some long needle nose pliers to pull that clip off and the arm rest can be slid out of the seat. On the bottom side of the armrest you will see how to unhook the armrest cover and slide it off the arm.
Remove the 2002 Ford Explorer drivers side inside door panel. The entire window mechanism will be visible. Locate and repair the cause for the window malfunction.
Replace the window regulator.
I have a 2000 Contour and there was a 19mm stud between the armrest and seat. It is hard to see and get the wrench on.