answersLogoWhite
Chevy Blazer
Air Filters and Intake Manifolds
Ford Escape XLT

How do you repair the intake manifold on a 1997 Blazer?

616263

Top Answer
User Avatar
Wiki User
2015-07-15 20:49:16
2015-07-15 20:49:16

usually your intake manifold is ok...the manifold gaskets are prone to failure..they are plastic with rubber impregnated seals...if the manifold is actually pitted, you can repair with JB WELD then sand smooth....

ase master certified tech

1

Related Questions

User Avatar

i suggest you get a repair book.it is not easy

User Avatar

Assuming this is a 4.3L engine, the fuel pressure regulator is located under the upper intake manifold. The upper intake manifold must be removed to gain access to the regulator.

User Avatar

It is on the firewall end of the intake manifold below the distributor

User Avatar

It is attached to the bank of fuel injectors (the spider) under the upper intake manifold.

User Avatar

intake manifold is under the throttle body

User Avatar

What are the intake manifold torque specs on 1998 Oldsmobile bravada?"

User Avatar

Assuming you have the 4.3L engine it would be located under the upper intake manifold. After removing the upper intake manifold you will see the fuel pressure regulator attached to the bank of injector "poppets".

User Avatar

The Villager has an upper and lower intake manifold. It is at the top of the engine with the throttle body attached to it.

User Avatar

where is intake manifold runners control stuck 1997 lincoln continental

User Avatar

Intake manifold gaskets are leaking, intake manifold is warped.

User Avatar

located on the intake manifold just follow the upper radiator hose to the engine should be 2 bolts holding the thermostat housing down.

User Avatar

http://d-tips.com/General/Articles/article.aspx?id=/free/How%20to/GM%204.3L%20Intake%20Manifold%20repair/43intakearticle.art

User Avatar

The 1997 Mercury Cougar 4.6 liter engine intake manifold torque sequence should begin at each end of the manifold. Keep moving towards the center and alternating from and to end.

User Avatar

coolant by pass hose needs repaced under intake manifold to water 1996 Lincoln town car

User Avatar

After the air filter and on the intake manifold

User Avatar

On the 1992 2.3 it is behind the upper intake manifold, about even with the lower intake manifold (driver's side).This puts it between the manifold and the firewall.

User Avatar

You won't see it unless you remove the upper intake manifold. It is attached to the bank of fuel injector poppets (aka, the spider).

User Avatar

in between the firewall and intake manifold

User Avatar

It is located on the rightside of the intake manifold, infront the intake air tubing, sensor is in a vertical position, straight down in to the manifold.

User Avatar

It is the metal pipe that runs down both sides of the intake manifold.It is the metal pipe that runs down both sides of the intake manifold.

User Avatar

Your intake manifold gasket needs to be replaced.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.