Your 1988 Nissan 300 speedometer cable is held in place with swivel nuts on each end of the speedometer cable. Turn the swivel nuts to the left. The speedometer cable will come off. Reverse the process to install your new speedometer cable.
You can replace the speedometer cable, on your 1988 Ford Ranger, by loosening the cable nut on each end of the cable. The cable will come off and can then be replaced.
They don't allow pasting pictures in here. The speedometer cable goes from the transfer case to the speedometer.
Remove the cable housing from the rear of the speedo and pull the cable out, then take it loose at the trans and remove the piece that is broken off. Get a new cable and when reinstalling it grease it good with special speedo grease.
The 1988 Suzuki Samurai speedometer cable diagram can be obtained from most Suzuki dealerships. The speedometer cable diagram can be found in most service manuals.
One end at the speedometer head The other at the side of transmission
The speedometer cable connection is on the transmission tail shaft housing, drivers side. They went electric (no cable) in 1988 in the trucks.
it goes into tranny behind transfer case
The question you ask is too involved for a proper answer. You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.
I have a 1988 300zx non turbo... and i have a speedometer cable that connects to the transmission as well as the speed sensor that is near the front passenger side of the car.. it is near the vacuum. its a little round thing mounted to the car with 3 wires and a cable coming out of it.
buy a chilton it explains, no dipstick on the manuals. speedometer cable is the dipstick
May have to take the car to a certified speedometer repair shop