Haven't looked at a Buick for a long time, but the older ones it used to be either the short cable from the cruise control to the speedometer or the control module itself. Drivers side inner fender, right on top. Don't know if they were still using the same system in 92 or not but imagine they did.
buick roadmaster 1992 rear axle does it have limited slip diff
350
A 1992 Buick does not have an inertia or fuel cut off switch.
Need to now
5 quarts with a filter
No. It's 1.5 din.
The 1992 Buick Roadmaster signal flasher relay switch can be found beneath the drivers side dashboard. The signal flasher relay switch will be above the gas pedal.
The computer on a 1992 Roadmaster is located directly under the dash of the automobile. This makes it accessible for those who require a repair to the vehicle.
its a 350hp vortec engine.
180 hp
18436572 ~FN~ www.forumnut.net
rear wheel drive
If the transmission won't shift out of first gear on a 1992 Buick Roadmaster, it could indicate the transmission gears are seized. It can also indicate a low fluid level.
Yes they will fit cause i have a 92 roadmaster and they fit perfect
a metal tag is located in the lower drivers side of the windshield
Yes
speedometer--vehicle speed sensor is in trans near pass side axle
Ebay or you can download it from http://www.extendedgmwarranty.com/owners-manual/buick_owner_manuals.html
Buy the Chiltons or Haynes manual. It will walk you through the process.
Component Location View. RH Lower Instrument Panel
Vehicle Speed Sensor
The answer to this is too complex and you need special tools...sorry..Rick D
Buy a kit at Wal-Mart or auto parts comes with adaptors, fittings and instructions
I believe it is the 4L60 which was orignally named the 700R4. But it was renamed when the 4L60E was introduced.
Slow insert a flathead screw driver in the slot provided and push, hubcap will pop out