Remove the two screws on the top and then gently pull the cover off from the top. It will sound bad, like something is breaking. There are two wires connected to the bulb inserts. Again gently turn the bottom one and pull it out. There you will find the bulb. Push in the two sides of the bulb and then pull the bulb out. It's not hard. I am a 49 year old woman and I figured it out!
how to replace the brake light switch at the pedal of a 2001 ford zx2
How do you replace the rear brake light bulb on a 2001 Honda civic?"
To replace the brake light on a 2001 Dodge Durango the light lens must be removed. It is held on by a clip on one side and a hinge on another. It opens like a door to access the brake light housing.
To replace the brake light bulb you need to remove the whole light assembly. Once removed the change is simple.
anonymously
check brake light switch on brake pedal maybe getting bad
remove tail light and reach through
Remove the tail light housing and replace the bulbs.
This is usually cause by a stuck brake light switch on the brake pedal. Replace it.
If the brake fluid level in the brake master cylinder is low ( in your engine compartment ) that will also turn on your emergency brake light just as if the emergency brake was applied
Check your brake fluid level in the brake master cylinder in your engine compartment when it is low your brake warning light will come on
Go to Macho shouldn't they have one