replace the axel!!! not just the joint. you have to remove the ball joint and the tie rod end. just remove the nut off the bottom of the tie rod end and it shouldn't mess up your alinement. then you have to remove the nut that is under your rim so you must remove your tire. and take that nut off also. and replace the wheel baring also if your going to replace stuff anyway.I think auto zone had a lone a tool program or something to remove the axel from the tranny. it just pops out. its easyer then it looks.
Look in this web site for complete instructions: www.techcapri.com.
A 1993 Mercury Capri (with the 1.6 4 cylinder DOHC engine) requires 3.2 quarts of oil.
Remove the positive cable from your 1993 Mercury battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.
yes it will, just put a 91 in my 93......email me if you want....email@example.com
Remove the tire and wheel from your 1993 Mercury Cougar. Remove the ball joint retaining nut. Pound the ball joint out with a hammer. Reverse the process to install your new ball joint.
The spark plug gap for a 1993 Mercury Capri 1.6 L - DOHC - 4 cylinder engine is : ( .044 inch )
The CV joints on a 1993 Mercury Villager can be replaced by removing the front tires and the brake caliber. Next, the rotor, tie rod, and bottom ball joint must be removed. Then, a pry bar can be sued to pry the CV joint away from its housing.
1993 mercury marquis
Most parts on the cars are interchangeable from 91' to 94' the only things you have to watch is the convertale tops.
As far as I know thevoltageregulstor is integral to the alternator.
I need to find out how to replace a fuel pump for a 1993 Mercury Topaz, 4 cylinder, fuel injection
You can find the wiring diagram for the 1993 mercury capri at the following site. This manual is very acurate for all the things pertaining to the 90's capri. www.techcapri.com This site has just about everything you need for this little car. Good luck.
http://www.techcapri.com/Repair/Capri_Service_Manual.htmthis link will give you all of the information you will need
it is just above oil filter to the left
Most likely it is the fuel level sending unit that has gone bad. This would have to be replaced.
price on replaceing ball joint 1993 cutlass supreme
IF anyone has any imfo on how best to replace an ignition system on a 1993 Mercury topaz please call 714-6383162, or e-mail me at KN657@yahoo.com
THE HORN ON A 1991 MERCURY CAPRI IS LOCATED UNDER THE HOOD!!!!!!!!!!!!!!!! Actually, it is located under the Driver's side headlight tray (look from underneath car and you'll see it). Give it a good spray with WD-40 or PB Blaster if it's not working...
I looked in a repair manual and it said that the gap for a 1.6 l is .040
yes it comes with hard top a toneau top and soft top.
picture on how to replace a water pump for mercury topaz
check on eBay for a power window motor. from what i have heard its only 1991 -1994 mercery capri only
you will need to pull the gas tank out N0 Need to pull the tank, see answer in other questions on this. Bob