Step by step: 1. Open the glovebox, and empty it. 2. Squeeze the sides of the glovebox and drop it down. 3. Squeeze the tab on the connector to the resistor pack (hidden in the pic below, it's on the left). 4. Remove the 8mm hex-head screw holding the resistor pack. Once loosened, it can be unscrewed by hand (don't drop the screw!). 5. Lift the resistor pack from the bottom, it swings up and out.
Installation is the reverse of removal. Don't overtighten that screw!
More Information:
I found out how to change it.My focus 2002 tdci heater blower was not working or only blowing on high,its the blower resistor.To change it pull down glove box sqeeze in the sides and drop it right down and disconnect the little rod holding it up.the resistor is on the right side retained by one screw.Just disconnect the wire and unscrew the screw and out it comes, it is a bit awkward to get to but youll get the hang of it.Replacement is is easy but watch you dont drop the screw.all in all took me about 5 minutes out and 5 minutes in. Now my blower is great.On the focus they usally blow when water gets in through the pollen filter housing,i siliconed mine when i changed the filter.
The blower motor resistor in the us models of the Ford Focus is behind the glove box, against the firewall, to the left of the actual blower motor.....my stock one was blue. it is only held in by one screw....just unscrew it and pull it out. They are like 15 dollars from the dealer.
Check to see if you are getting power to blower motor - if so replace blower motor If not check fuse, switch, resistor pack.
To replace a blower motor on the resistor first you take off the nozzle and then you go into the motor through the nozzle and unlock it then repeat and oil and done.
With great difficulty!
You need to replace blower motor resistor.
replace the blower motor resistor
where is rear blower motor resistor on a 2001 odyssey
The resistor pack has 3 resistors on a rectangular blue carrier held down by 1 screw onto the firewall behind the glove box to the left of the blower motor. You have to remove the glove box in order to replace the resistor pack.
The 2001 Nissan Quest blower motor resistor is located on the firewall in the engine compartment. The blower motor resistor will be on the passenger side of the firewall.
`your resistor pack is burned up. it is accessible behind glove box . easy removal and replace
The heater blower in a 2001 Hyundai XG300 is located on the passenger side of the engine. The blower resistor will be located on the firewall.
Where is the resistor on 2001 jeep wrangler