Open the trunk. On the side of the lamp housing facing the trunk there are two 6pt screws. Remove these two screws and you will be able to grab hold of the lamp housing (the entire tail light assembly) and slide it out towards the rear of the car. Now you can access the bulbs from the rear of the lamp housing.
Just received letter for recall to replace entire tail light assembly. Check with dealer to see if your car is covered.
To replace the brake light on a 2000 Ford Explorer, remove the screws holding the brake light in place. Gently, but firmly, pull the brake light out of the vehicle and replace with a new one.
There is a campaign on the brake bulbs for 2000-2003......If it hasn't been done you should get it done. The bulbs and sockets will be replaced.
how to replace the brake light switch at the pedal of a 2001 ford zx2
To replace the brake light on a 2000 Pontiac Montana open the trunk to reveal the housing units. Find the lights and pull the bulbs out. Replace the units.
Pull the carpeting behind the brake light. Unclip the assembly, replace bulb.
i have a Frontera sport 2000 and not sure how to change brake light bulb
How can I replace the headlamp on a 2000 Saturn SL1
There is a sensor in the top of the brake cylinder where you put in the fluid. Replace it and the light will go away.
Just unscrew the rear brake light, turn out the socket, and replace the bulb.
check your local mechanic
How do i replace brake lines on a 2000 grand am
In the top of the trunk near where the brake light is located, there is a small plastic window, remove it and you access the light bulb.
Original equipment part for brake light replacement on 2000 Honda Odyssey EX is: 7443 W21/5W STANLEY 12V 03U E4 2DW
The 2000 Saturn does not have a distributor. Instead it uses a "coil pack" system.
Brake light, on your 2000 Chrysler Concorde, by accessing it from the inside of the trunk. Take hold of the brake light, push in and turn. The brake light will come out.
You need a star point screwdriver. Remove the 2 screws pull out light assembly. Remove the light socket from housing and replace bulb. replace in reverse order. 5 minutes.
No, it is a brake light.
Depending on what you mean ,to change a bulb on the 2000 you need to open the rear door on the side of the light you will see two screws take those out and the light will come out.
my back brakes lights won't work but the one in the back window does
The brake light switch is on a bracket just above the brake pedal.
change fronadst brake
You can access the middle brake light from the inside of your 2000 Dodge Neon cargo compartment. Remove the brake light wiring harness. Remove the brake light retaining bolts. Reverse the process to install the new brake light.
The left brake light works the right brake light doesn't and the bulbs is good
take it to a shop
Inside the trunk behind where the brake lights are are a plastic cover. Remove that and you will see one bolt. Reach in to the far side of the light and you will find the second bolt. Remove those and the brake lights can be pulled out. Now just twist the bulb holders and there are your brake light bulbs.