from the trunk look up towards where the lamp is there you will see a two/three wire connection/socket at the lamp... turn the connection/socket about 1/4 to 1/2 turn to the left and pull down slightly you'll find a burnt out bulb...... replace and re-install connector/socket in the reverse of removal..... P.S. Dont get locked in the trunk..... lol
if your lamp is on the top of your rear window then either carefully snap off the cover from inside the vehicle that covers the lamp or remove 2-3 screws from the cover (if applicable) and there you will find the bulb.....
ya out!!!!
Pauly Pauly
Why ? Just replace it.
check your brake lights if they not worhing replace fuse or brake light switch
To replace the brake light on a 2000 Ford Explorer, remove the screws holding the brake light in place. Gently, but firmly, pull the brake light out of the vehicle and replace with a new one.
How to replace a brake light on a nissan Tiida hatch back.
To replace your brake light, you need to unscrew the brake cover from the inside of the trunk. Then you will be able to pull the old bulb out and replace it.
Remove the wing nuts from inside the trunk, the assembly will pop out.
how to replace the brake light switch at the pedal of a 2001 ford zx2
how to replace brake light bulb fiat doblo van
to replace dome light in suzuki grand vitara
Your brake light is probably brake fluid low or emergency brake on. Rear brake lights are replaced by removing the lens and replacing the dual filament bulb.
How do you replace the third rear brake light in a 2005 buick allure
APPLY BRAKES AND SEE IF BRAKE LIGHTS COME ON. IF NO BRAKE LIGHTS, REPLACE THE BRAKE LIGHT SWITCH LOCATED ON THE BRAKE PEDAL ARM AND THIS SHOULD ALLOW YOU TO SHIFT OUT OF PARK. IF THAT BRAKE LIGHT SWITCH IS BROKE, YOU WON'T BE ABLE TO GET IT OUT OF PARK
To replace the dome light on a Grand Am, unscrew the light cover. Pull it down gently. Disconnect the light. Connect the new light, replace the light cover, and replace the screws.
Where is the brake light fuse found on a 1996 dodge grandcaravan
There could be a separate fuse for the lower brake lights , or maybe both lower brake light bulbs are burned out
Pull the carpeting behind the brake light. Unclip the assembly, replace bulb.
How do you replace the rear brake light bulb on a 2001 Honda civic?"
3rd brake light or rear brake lights?
Check the sensor on the brake pedal arm.
THAT IS USUALLY AN INDICATION OF A BURNED BRAKE LIGHT SWITCH. SWITCH IS USUALLY LOCATED ON THE BRAKE PEDAL ITSELF. DISCONECTED AND IF THE LIGHTS GO OUT YOU HAVE FOUND YOUR PROBLEM , SIMPLY REPLACE IT.
To replace the brake light bulb you need to remove the whole light assembly. Once removed the change is simple.
The light on the dash that says the emergency brake light is on could have burned out if it does not light up when the emergency brake is actually on. In some vehicles, this light will not light up until the car is put into gear to warn the driver that the emergency brake is still on.
How do you remove cover to replace brake light on 57 kia Rio
The 1993 Jeep grand Cherokee brake light switch simply plugs in and out. The brake light switch is located beneath the dashboard on the drivers side of the engine compartment.
Replace the brake pads.